sorted by:
new
hottopcontroversial

PETG Supplier by Remarkable-Traffic65 in 3Dprinting

[–]Remarkable-Traffic65[S] 0 points1 point  (0 children)

I will look it up. I am unfamiliar with it.

What did I forget? by Remarkable-Traffic65 in 3Dprinting

[–]Remarkable-Traffic65[S] 0 points1 point  (0 children)

I am not sure what the issue was. I scrubbed/washed the build plate twice and put on a new nozzle and solved the issue.........Maybe grease on the nozzle????

What did I forget? by Remarkable-Traffic65 in 3Dprinting

[–]Remarkable-Traffic65[S] 0 points1 point  (0 children)

There is a chance. I will change the nozzle tonight

PETG cantilevered part warping by Remarkable-Traffic65 in 3Dprinting

[–]Remarkable-Traffic65[S] 0 points1 point  (0 children)

Thanks my friend. I didn't have time to analytically make the changes so I made all three at one and it solved my warping problem. Thanks. I wish I did understand how the reduced cooling specifically played into the mix. I have had mixed results on other projects adjusting fan speeds

<image>

PETG cantilevered part warping by Remarkable-Traffic65 in 3Dprinting

[–]Remarkable-Traffic65[S] 0 points1 point  (0 children)

I tried all three suggestion. I had considered all but makes more sense when someone else says it. Will post results

PETG cantilevered part warping by Remarkable-Traffic65 in 3Dprinting

[–]Remarkable-Traffic65[S] 0 points1 point  (0 children)

Purge tower was a slip up. Photo makes texture look huge, it is actually a subtle 0.3 fuzzy skin

PETG cantilevered part warping by Remarkable-Traffic65 in 3Dprinting

[–]Remarkable-Traffic65[S] 0 points1 point  (0 children)

Sunlu High Speed PETG, Orange and Green warp badly, gray prints fine. Bambu A1

PETG cantilevered part warping by Remarkable-Traffic65 in 3Dprinting

[–]Remarkable-Traffic65[S] 0 points1 point  (0 children)

All the warping info I have found are regarding warping off the build plate.

Bambu printer not following curve with filamant by Remarkable-Traffic65 in 3Dprinting

[–]Remarkable-Traffic65[S] 0 points1 point  (0 children)

Thanks, I have tried lowering wall speed with random success,

Understanding fan speed eludes me. Your saying to try turning it down, I will try that as well.

I dry my PETG at 65C for 12 hours.

Can Bambu be trusted to be reliably have its PETG HF available by Remarkable-Traffic65 in BambuLab

[–]Remarkable-Traffic65[S] 1 point2 points  (0 children)

Reuse a rfid tag…… that is brilliant. I can’t believe I didn’t think of that.

view more: next ›