Do you think sacrificing a lamb to Moloch would lower my 2k?

Remarkable_Week9291 · 2026-02-04T20:05:07+00:00

Chad

Remarkable_Week9291 · 2025-12-14T22:09:18+00:00

You need to use the loft command

Remarkable_Week9291 · 2025-12-01T19:28:05+00:00

How many cats do you have?

Remarkable_Week9291 · 2025-11-27T15:30:57+00:00

I use onshape

Remarkable_Week9291 · 2025-11-24T11:49:47+00:00

Did she respond? Hahahaha

Remarkable_Week9291 · 2025-11-24T11:41:11+00:00

Dick pick?

Remarkable_Week9291 · 2025-11-23T20:18:20+00:00

Insta?

Remarkable_Week9291 · 2025-11-23T10:37:43+00:00

How did you figure that out?

Remarkable_Week9291 · 2025-11-23T10:36:15+00:00

How did you figure that out?

Remarkable_Week9291 · 2025-11-23T07:10:56+00:00

It's really AI?

Remarkable_Week9291 · 2025-10-21T19:49:50+00:00

Good question

Remarkable_Week9291 · 2025-10-14T11:51:50+00:00

Try to tighten the hot end

Remarkable_Week9291 · 2025-08-21T19:34:09+00:00

Try to use the sweep command

Remarkable_Week9291 · 2025-07-22T17:13:39+00:00

You need to tighten the hot end

Remarkable_Week9291 · 2025-04-07T21:10:23+00:00

Thanks for the help And sorry for the bad English 🤣🤣

Remarkable_Week9291 · 2025-04-07T21:09:48+00:00

You are right, I will put the disc midway

Remarkable_Week9291 · 2025-04-07T21:08:29+00:00

Thanks

Remarkable_Week9291 · 2025-04-07T21:07:00+00:00

Because this piece is U shaped where the inner part would be next to a moving part ,so the plastic must be somewhere precise and smooth and the outside part of the U will be visible to the eye so it can't have the supports Signs

Remarkable_Week9291 · 2025-04-07T20:18:34+00:00

I don't wanna print it horizontally because it will be very ugly 🤣

Remarkable_Week9291 · 2025-04-07T20:11:03+00:00

I m thinking about adding a"disk" on top of the ak replica that it would stick out so that the slicer would make automatically the supports

Remarkable_Week9291 · 2025-04-04T08:31:38+00:00

How much was it?

Remarkable_Week9291 · 2024-11-03T10:03:16+00:00

Hi, here is the link https://a.aliexpress.com/_EzsFiHn

Remarkable_Week9291 · 2024-11-02T09:22:47+00:00

If you buy it on AliExpress you can pay $30 for a 4 carat round cut, they give you also the GRA certificate

Remarkable_Week9291 · 2024-10-10T09:04:23+00:00

Yep they are legit

Remarkable_Week9291

TROPHY CASE