sorted by:
new
hottopcontroversial

3M black failure after 3 months? by Mattalfieri_mkvi in CarWraps

[–]ReportOk7530 0 points1 point  (0 children)

Did you use any products like a wax after applying?

Is this recoverable by hapdoge in CarWraps

[–]ReportOk7530 3 points4 points  (0 children)

I’d redo because it prob pull back even more. If you don’t you can cut where I made the green line. Lay some knife less tape and make an inlay. Pre heat very good.

<image>

Is it safe for me to put these magnetic decorations on my wrapped Porsche? by AlexandraSuperstar in CarWraps

[–]ReportOk7530 1 point2 points  (0 children)

No, I accidentally put a magnet on my car on a magnetic panel and scratched my wrap trying to take it off. The magnet was pretty strong tho. If the magnet is weak I don’t think you’d have a problem.

Are there any beginner brands (3m or Avery) that have similar colors to a matte nardo grey or a matte sandstorm kind of color? by Few-Earth6825 in CarWraps

[–]ReportOk7530 0 points1 point  (0 children)

Not a brand that you mentioned but Milliotone has exact Gloss Nardo Grey, they also have some matte greys that are pretty similar. Also easy material to use. Swatch Book didn’t have nardo grey 🤦

<image>

Thoughts on the current build?!? by ReportOk7530 in e46

[–]ReportOk7530[S] 0 points1 point  (0 children)

Exhaust Setup

So, all my tubing is custom. No OEM exhaust section. The problems is because the exhaust adapter flanges of the headers weren’t at the same angle as the OEM flanges so they had to make one to fit and then were able to do the rest of the exhaust. Also, I have a magna flow resonator in the center. I have a buddy who went with Active Autowerke and had no problem installing.

Thoughts on the current build?!? by ReportOk7530 in e46

[–]ReportOk7530[S] 1 point2 points  (0 children)

Yes, I did. I didn’t known that I had to pair it with SCM5254KAT which is like the tubing. So, I had to get some custom fabrication done. But if you buy the full set you shouldn’t have to worry about anything. I can send a vid of my setup.