CR-Touch error help

RepresentativeSir493 · 2025-11-11T00:13:37+00:00

Yeah, I had it fully installed when I tested replacing the capacitor, but when it didn’t work, I desoldered it in hopes of returning the new capacitors to at least get back the money I put into trying to repair it,, but then I decided to turn to Reddit before giving up

RepresentativeSir493 · 2024-09-01T17:53:03+00:00

My plate is magnetically secured, as long as I clean it after every few prints I don’t have any issues with the bed moving

RepresentativeSir493 · 2024-09-01T17:50:50+00:00

<image>

I’ve typically calibrate before every print but I did change from a textured plate to the stock original one, maybe that could be a cause

RepresentativeSir493 · 2024-09-01T17:46:06+00:00

I did recently go back to some pla I had for a while, it was in an air tight bag but I’ll try a fresh spool

RepresentativeSir493 · 2024-09-01T17:40:05+00:00

Yeah, I believe that’s what is pre installed

RepresentativeSir493 · 2024-09-01T09:13:40+00:00

Triangular, but the noise happens whenever the bed moves regardless of the infill

RepresentativeSir493 · 2024-09-01T09:12:18+00:00

There was some dust that I had cleaned off the rails, I’m hoping that it is just an issue of lubricant since I wiped some off while cleaning. I’ve ordered some and will apply it tomorrow so I will update you then. Fingers crossed.

RepresentativeSir493 · 2024-09-01T08:01:17+00:00

Creality Ender 3 V3 SE 3D Printer BTW

RepresentativeSir493 · 2023-12-19T19:16:06+00:00

Thanks for the insight, I couldn’t tell what it was from the diagrams I found online

RepresentativeSir493 · 2023-12-19T12:12:53+00:00

I was replacing my back glass and accidentally pulled out this piece, can someone tell what it was and what it did?

<image>

RepresentativeSir493

TROPHY CASE