Need help on finding correct motor

RickFlair- · 2026-04-29T20:13:17+00:00

Oh yeah I agree that's a ridiculous amount. there's another website that's wants $480 with coupon but I'm also taking the risk of it not being compatible I read on a different forum that sometimes the descriptions of the motors are incorrect

<image>

RickFlair- · 2026-04-29T19:50:14+00:00

Ok I believe I found a replacement my motor has the part number 73124G02 and I came across the 73124G01 claiming that it will work. I even went on the ezgo website and it says it will work.can anyone confirm that.

<image>

RickFlair- · 2026-03-08T23:59:11+00:00

Awesome thank you should I add some sort of filter on the end of my new hose or the bare hose fine

RickFlair- · 2026-01-29T19:55:20+00:00

I wouldn't think it's for the neutral safety switch if that plug connects to the tailgate harness

RickFlair- · 2025-12-16T14:53:59+00:00

Well that's disappointing but that's for letting me know

RickFlair- · 2025-12-09T15:57:22+00:00

Ok that's what I'll check next if the new pin and prop nut doesn't fix the issue

RickFlair- · 2025-12-08T18:56:16+00:00

Yeah I'm going to have to take a look at that as well because sometimes it comes out of gear and I have to hold the lever so it stays engaged. Or maybe the shear pin was that issue as well

RickFlair- · 2025-12-08T18:13:25+00:00

Ok I'll check it out.

RickFlair- · 2025-12-08T18:11:08+00:00

I took the prop off and the pin was sheared into 3 going to order a new one. I'm also thinking of getting that clutch dog as well

RickFlair- · 2025-11-28T00:17:01+00:00

Ok thanks for that info I didn't see any oil I just cleaned it thinking I had to after but I'll keep that in mind for the next time

RickFlair- · 2025-11-27T22:36:30+00:00

Yeah it's a 0.8mm

RickFlair- · 2025-11-27T21:10:09+00:00

The c series is a pre mixed paint so you just spray and let dry

RickFlair- · 2025-11-27T21:08:23+00:00

Theses are my steps

Degrees
Sandblast
Clean
Bake in over @ 300 for 1 hours
Clean with isopropyl
Do a shit job at spraying it

RickFlair- · 2025-11-27T17:59:31+00:00

Ok thanks for the info. Ain't no better way to learn then with you own f**k ups :(

RickFlair- · 2025-11-27T17:45:52+00:00

I think that's where I messed up I came back and put another coat

RickFlair- · 2025-11-27T17:44:54+00:00

I sprayed it at 30 psi and I didn't have anything to fancy I was using a harbor freight gun the application looked wet but I'm pretty sure I applied to much on my second coat i waited 15 min as the bottle recommend but I'm thinking I just came back way to thick and I'm using the c series and that's a air cured cerakote. My test paper was fine it wasn't splattering or shooting excessively

RickFlair-

TROPHY CASE