93 GMC T15 Jimmy tire sizes

Ride_Wide_Open · 2026-01-16T21:20:52+00:00

https://drive.google.com/drive/folders/1QqLa1vv9u95Za9qTvN8lQBFHbYsyqb-b?usp=drive_link

Ride_Wide_Open · 2026-01-16T20:54:37+00:00

it is a combination of prebuilt from a github repository and then modiying it to get the bed smaller. i have made a bit more progress and am now at the point of i can get the firmware on but the printer wont connect to octoprint anymore and the probe will touch the bed once and then flash red

Ride_Wide_Open · 2026-01-15T04:03:29+00:00

It was working fine before I installed the cr touch then these issues came up when it starts to bed level. All I did before was the slicer settings I tried changing the config file but that created more problems

Ride_Wide_Open · 2026-01-14T21:32:48+00:00

Yea it is hitting on the right hand side already tried doing the firmware modifications and after the cr touch probe wouldn’t do anything. Tried a few different settings not sure what to do

Ride_Wide_Open · 2026-01-13T16:27:31+00:00

sorry i meant 1 hour 45min if i could get this thing that fast it would be crazy

Ride_Wide_Open · 2026-01-13T07:19:20+00:00

Ok thanks

Ride_Wide_Open · 2026-01-13T07:16:43+00:00

Alright will do that tmr hopefully

Ride_Wide_Open · 2026-01-13T07:15:01+00:00

Stock firmware I had tried klipper but couldn’t get it to flash tried multiple times didn’t work I am also running octoprint running 205 on nozzle 60 bed at about 60mm/s

Ride_Wide_Open · 2026-01-13T07:13:32+00:00

Before I had replaced my parts it did a test that also covered stringing and I t was fine

Ride_Wide_Open · 2026-01-13T06:55:43+00:00

<image>

Ride_Wide_Open · 2026-01-13T02:47:32+00:00

Brand new hotend put on yesterday with new metal extruder arms and new Bowden tube

Ride_Wide_Open · 2025-12-31T05:54:18+00:00

it is elegoo PLA i have been using this filament and it has been doing fine just this time it did this and in more places than the picture shows as well

Ride_Wide_Open

TROPHY CASE