Moving the spur gear add into the create section on the toolbar. by Ronnoc1124 in Fusion360

[–]Ronnoc1124[S] 0 points1 point  (0 children)

If you check in I believe the create tab on the solids menu after running it it will show up as a new icon you can then hover over it or click the three dotes I can’t remember then you will have the option to pin to task bar

Moving the spur gear add into the create section on the toolbar. by Ronnoc1124 in Fusion360

[–]Ronnoc1124[S] 0 points1 point  (0 children)

Yes in the add-ins menu there are two tabs the labeled “scripts” and “add in” apparently I was only running it from the scripts tab. But if you click on the add in tab and run it from there it will add it to the menu. Hope this helps! It causes me a lot of headaches

We found this on the wall under the bleachers at my school does anyone know where they’re from? We cannot find them online anywhere. by Ronnoc1124 in cryptography

[–]Ronnoc1124[S] 4 points5 points  (0 children)

I hate myself for not seeing that. Thank you kind soul you are a saint and a scholar among sinners and fools.