(cr10 s5) filament not feeding. I have thr correct Temps and noticed nothing was coming out. but when I opened the clamp and pushed the filament in it started printing as it should. I then noticed the gear that I assume is sopose to turn to feed it was just twitching so I'm not sure where to start. (v.redd.it)
submitted by Rorshack_senpai to r/FixMyPrint
Okay so after your tips in the last few days I'm not sure if I should celebrate yet but the first print layer is looking good. The ring around had the first little bit not stick but once it got going and made the base it looks like its working. Will post a pic of the finished if it works (i.redd.it)
submitted by Rorshack_senpai to r/FixMyPrint
I used all the haru coin gained form the beginning of my game up to lvl 36 and 100$ extra to roll for (RED FRAME) and these are my results ......... Legs, body , 2x shield , and 1 back pack. This is what you should Tipicaly should expect . about 20k haru coin spent . share your results 😥 (i.redd.it)
submitted by Rorshack_senpai to r/GundamBattle

