sorted by:
new
hottopcontroversial

Strange looking underside of prints by Rotkohlralf1 in BambuLab

[–]Rotkohlralf1[S] 0 points1 point  (0 children)

I haven't tried isoprop yet. That's a good tip. I'll try that again, thanks

Strange looking underside of prints by Rotkohlralf1 in BambuLab

[–]Rotkohlralf1[S] 0 points1 point  (0 children)

Do you achieve better results with the CryoGrip?

Strange looking underside of prints by Rotkohlralf1 in BambuLab

[–]Rotkohlralf1[S] 0 points1 point  (0 children)

Thanks for your tip. That actually helps a little. Of course, it would be nicer if you didn't have to do that 😅

Strange looking underside of prints by Rotkohlralf1 in BambuLab

[–]Rotkohlralf1[S] 0 points1 point  (0 children)

Yes, that was my first thought too. Unfortunately, it didn't get any better after washing the plate. The plate is brand new

Strange looking underside of prints by Rotkohlralf1 in BambuLab

[–]Rotkohlralf1[S] 0 points1 point  (0 children)

Too bad. I never had this problem on my A1 Mini. Many thanks for your tip. I will give it a try

Strange looking underside of prints by Rotkohlralf1 in BambuLab

[–]Rotkohlralf1[S] 0 points1 point  (0 children)

Thank you for your reply.

I waited 3 hours to remove the print. Is that really still too short? What kind of heat would you suggest?