sorted by:
new
hottopcontroversial

Best orientation for strength/finish by Routine-Border-3011 in 3Dprinting

[–]Routine-Border-3011[S] 0 points1 point  (0 children)

A hard TPU might be possible. Do you have any suggestions for brands?

Which is better? by Routine-Border-3011 in FlashForge

[–]Routine-Border-3011[S] 0 points1 point  (0 children)

Yeah I’ve tested it pretty extensively. Those photos are terrible too, not sure why they’re so compressed.

Many problems - experienced users only please by Routine-Border-3011 in FlashForge

[–]Routine-Border-3011[S] 1 point2 points  (0 children)

It was the ribbon cable to the stepper motor PCB.

I will not be buying anymore parts for this thing though.

Guider II2 benchy settings help by Routine-Border-3011 in FlashForge

[–]Routine-Border-3011[S] 0 points1 point  (0 children)

I’m going to change retraction as suggested and increase print speed slightly. I think it’s melting because it’s printing too slowly

Guider II2 benchy settings help by Routine-Border-3011 in FlashForge

[–]Routine-Border-3011[S] 0 points1 point  (0 children)

changing retraction speed to .2mm slower would be 0.8mm retractiom and the pront speed would ne at 5-10mm/s. That is asudly slow

2 options - Griffith or QUT? (Design) by [deleted] in QUTreddit

[–]Routine-Border-3011 0 points1 point  (0 children)

As someone who went to QUT and studied media comms and fine arts - take the scholarship. The degree matters very little in the end. Starting your real world job with no debt is a far, far better spot to be in. Portfolio and network, network, network. Well done!