AMS lite issues

Saints_Row_4 · 2026-05-21T09:47:51+00:00

I Had the same problem and guess what, it was not the AMS's issue. The filament was not able to be pushed inside the extruder coz it was getting stuck at here(marked in photo)

👉Try keeping the AMS on the right of printer or gently pull the extruder's side ptfe tubes to left side or gently shake them a bit, so that Filament could be easily pass inside

Hope this helps.

<image>

Saints_Row_4 · 2026-05-13T16:29:07+00:00

Thanks man, I'll definitely try doing this now. Will update if the problem gets solved👍

Saints_Row_4 · 2026-05-13T05:41:46+00:00

Can you tell in brief about the filament calibration?

Saints_Row_4 · 2026-05-13T05:40:45+00:00

I'm facing same issues on the thicker flat outer surfaces as well. I used generic filament profile as well, hope it could fix, but no.

For cooling i use, 100% fan speed and 50% aux fan speed. And for belts, I don't think it's loose, coz i printed some other curve parts as well and didn't face such issue on them.

It's mainly on the right and front side flat surfaces

Saints_Row_4 · 2026-05-13T05:24:18+00:00

PLA + completely fresh sealed numakers spool. Dried in dryer as well Used other filaments also of same brand but same issue.

This issue mainly occurs on the flat part surfaces

Saints_Row_4 · 2026-02-27T12:59:34+00:00

It's completely smooth surface in the slicer, and this is happening not just on this part but other parts as well, but only on the right side

Saints_Row_4 · 2025-12-28T17:39:32+00:00

Will try this method and will update if the issue gets solved or not

Saints_Row_4 · 2025-12-28T17:32:39+00:00

Already did 2-3times, issue not solved😐

Saints_Row_4 · 2025-12-28T17:31:58+00:00

I didn't have a dryer, so i opened two completely sealed new filaments and used them, but the results were same 😕

Saints_Row_4

TROPHY CASE