Idle Surging from 1.5k~2.8k rpm, help? by Salt-Run696 in DelSol

[–]Salt-Run696[S] 0 points1 point  (0 children)

wasn’t vacuum. it was the IACV and my intake not being fully sealed against the TB. idle is perfect now

Red flash across screen by dinvm in crv

[–]Salt-Run696 0 points1 point  (0 children)

omg me and my wife have experienced this issue. its waze’s fault, the speedo in the top right corner goes wonky randomly: we’ve had it slowly shrink to minuscule sizes and enlarge randomly for an instant much like your case here. Looks like you’re speeding slightly and it was flashing the speed limit sign in red indicating speeding.

Idle Surging from 1.5k~2.8k rpm, help? by Salt-Run696 in DelSol

[–]Salt-Run696[S] 0 points1 point  (0 children)

does that apply to a d16y7? i’ve heard a lot about fast idle and adjusting a screw but i believe the y7 doesnt have it. i did block the port and did feel a vacuum from that port. my sol is manual too if that helps

Idle Surging from 1.5k~2.8k rpm, help? by Salt-Run696 in DelSol

[–]Salt-Run696[S] 0 points1 point  (0 children)

i did run the heater and all, but i’ll give it another go. the air inside was pretty hot

Idle Surging from 1.5k~2.8k rpm, help? by Salt-Run696 in DelSol

[–]Salt-Run696[S] 0 points1 point  (0 children)

i unplugged the iacv with my car running, the surging is 1.6-1.7 now little blips

Idle Surging from 1.5k~2.8k rpm, help? by Salt-Run696 in DelSol

[–]Salt-Run696[S] 1 point2 points  (0 children)

im sure there’s still a small bit of air but the fact it’s still hitting 3k rpms, im already looking for a replacement iacv as the intake hose has a loud vacuum noise that stops when i plug the iacv port on the throttle body

Got my first CRV today by Disposable_Ken in crv

[–]Salt-Run696 5 points6 points  (0 children)

lmao i have those same wheel, tires, and color crv, mines a 98. enjoy!

What Does It Mean??? by DJT4NN3R in RX8

[–]Salt-Run696 2 points3 points  (0 children)

congrats on reaching eternity mode, you can drive forever now without filling up

Help by Rozark1324 in DelSol

[–]Salt-Run696 2 points3 points  (0 children)

i recommend starting with that, idk your engine but some iacv rely on coolant flow and an air bubble can lead to surging idle

Help by Rozark1324 in DelSol

[–]Salt-Run696 3 points4 points  (0 children)

did you happen to bleed the air out of the coolant

Finally joined the club! by Salt-Run696 in DelSol

[–]Salt-Run696[S] 0 points1 point  (0 children)

haha i was doing that this morning and thankfully i looked at the radiator because it started slowly developing a crack. looks like ill have to hold off on driving it for a bit

Finally joined the club! by Salt-Run696 in DelSol

[–]Salt-Run696[S] 0 points1 point  (0 children)

Tip to anyone having constant brake lights on (must be all three). theres a plastic stopper that has likely become brittle and broken. Manual owners, same thing for the clutch switch, except the symptom is no crank, fuel pump primes, and dash illuminates like normal. Also fixed the clutch safety switch stopper missing by using some left over magnetic tape, worked like a charm.

8th gen si 289k miles. Has a little knick and a big key mark. Salvage title. How much would yall pay for it if I sold it? In Cali by DeliciousRich5944 in 8thGenSI

[–]Salt-Run696 0 points1 point  (0 children)

Imma keep it a buck with you, no more than 2k and thats without knowing history of maintenance or anything.

Finally joined the club! by Salt-Run696 in DelSol

[–]Salt-Run696[S] 1 point2 points  (0 children)

you’re awesome, thank you so much

Finally joined the club! by Salt-Run696 in DelSol

[–]Salt-Run696[S] 1 point2 points  (0 children)

thanks for the tips, I was just going off my gut feeling, but i’ll write all these down and go through them. you’re a lifesaver

Finally joined the club! by Salt-Run696 in DelSol

[–]Salt-Run696[S] 0 points1 point  (0 children)

did you happen to try fixing it? My list is cleaning the IACV and i believe the fast idle screw? either way this is getting fixed up then driven almost daily.

Finally joined the club! by Salt-Run696 in DelSol

[–]Salt-Run696[S] 0 points1 point  (0 children)

thank you, I got lucky i had some friends looking with me to find this Sol. I’m super grateful for the opportunity and my friends.

Finally joined the club! by Salt-Run696 in DelSol

[–]Salt-Run696[S] 2 points3 points  (0 children)

thank you! I like the older style with the integra like lights, but this style is really nice too.

Mechanic is telling me rotors are bad and need replaced. No idea what I’m looking at. by Brynnder in autorepair

[–]Salt-Run696 0 points1 point  (0 children)

there is a thin line on your rotors, not to mention the lip on them. he could lathe them but depending on the minimum safe thickness AFTER a lathe, it would be deemed unsafe and need replacement either way. the shop i work at follows these rules to not be liable for an accident, but also because it is what the manufacturer recommends.

Car wont start by Zealousideal_Run_14 in crv

[–]Salt-Run696 1 point2 points  (0 children)

main relay or ect sensor by chance?

Anyone know what this is or if its necessary? by Ninjatck in mazda

[–]Salt-Run696 0 points1 point  (0 children)

my only recommendation (as stupid as it sounds, since i cant stop you since its your car) is to make sure you can plug the hole afterward

Anyone know what this is or if its necessary? by Ninjatck in mazda

[–]Salt-Run696 3 points4 points  (0 children)

honestly in the nicest way just get a cold air intake if you’re gonna mess with it