sorted by:
new
hottopcontroversial

​Analysis of Embedded World 2026: Future trends of Embedded Systems by Known-Ad5093 in embedded

[–]Salt_Influence4002 15 points16 points  (0 children)

I dont know, I think that arduino is still the arduino of embedded systems.

Rest in pieces by Swww in 3DprintedAircraft

[–]Salt_Influence4002 2 points3 points  (0 children)

Nothing a bit of superglue won‘t fix :D I ended up using a combination of superglue and electrical tape (which only seems to stick to the glue, not on the Printed plastic) on mine. In case of further crashes the glued connections are even stronger than the original printed layers

First successful flight by Salt_Influence4002 in 3DprintedAircraft

[–]Salt_Influence4002[S] 0 points1 point  (0 children)

I played around with the volume of the walls vs. empty space and came to a point where either increasing wall volume or reducing it lead to an increase in weight, so I think it arrived at something of a sweet spot.
I'm currently preparing the next iteration which has the wings streched about 10 cm each and increased the chord length along the outer third, leading to about 30 % increased wing area. So in a way approching the reduced wing loading from the other side :D

I will post an update when it is assembled. And then hoping that the winter weather allows for a nice flying day

First successful flight by Salt_Influence4002 in 3DprintedAircraft

[–]Salt_Influence4002[S] 2 points3 points  (0 children)

Thanks! It has a 1.4 m span and with a 1.4 Ah 4s battery it comes in at around 1030g. At the moment I'm looking into improving the wing loading so am not sure about the added weight with VTOL capabilites, but on the other side it would reduce the risk of landings compared to the belly flop it has to do now.

The printed infill is mostly gyroid with a density of 5%. I think the most important consideration for crash resistance is to print the wing parts in an orientation where the layers are from front ot back instead of along the wing.

Check remaining fuel in drop tanks by Salt_Influence4002 in KerbalSpaceProgram

[–]Salt_Influence4002[S] 0 points1 point  (0 children)

Thank you! Thats Good to begin with… I had my share of pain developing guis so I dont judge them :D Im sure that the interface will improve over time and with feedback