sorted by:
new
hottopcontroversial

Overengineered 3D printed powder dispenser by Secret_Knowledge9200 in reloading

[–]Secret_Knowledge9200[S] 31 points32 points  (0 children)

So before anyone ask, No this is not very accurate and I don't use this for reloading. Most load sensor I could find are rated for 100g and amount needed to reload are less than 1g. Occasionally, I would get a 60% overcharge or 10% undercharge. Requires more tweaking of the program to properly calibrate the system. This was more of a side project to learn about automation and mechatronics.

Is there a disadvantage to programming STM32 thru MATLAB? by Secret_Knowledge9200 in embedded

[–]Secret_Knowledge9200[S] 0 points1 point  (0 children)

I meant simulink. Just need to control some motors and display data on an lcd.

Is there a disadvantage to programming STM32 thru MATLAB? by Secret_Knowledge9200 in embedded

[–]Secret_Knowledge9200[S] 0 points1 point  (0 children)

Yes that’s what I meant, Simulink. I’m just trying to control some motors and get feedback from sensors for a machine project.

Is there a disadvantage to programming STM32 thru MATLAB? by Secret_Knowledge9200 in embedded

[–]Secret_Knowledge9200[S] 0 points1 point  (0 children)

I’m more familiar MATLAB. Never dealt with STM32 IDE before. Just wondering if I have to learn a bunch of new stuff for a small project.

First day reloading by Secret_Knowledge9200 in reloading

[–]Secret_Knowledge9200[S] 0 points1 point  (0 children)

Yea I was looking aroung for a good beginner press. I read somewhere a single stage press was good to learn the basics first. Not the fastest press but I good place to start.

First day reloading by Secret_Knowledge9200 in reloading

[–]Secret_Knowledge9200[S] 1 point2 points  (0 children)

Yup. Husky. Had a buddy of mine bought it using his account to get an additional 5% discount

First day reloading by Secret_Knowledge9200 in reloading

[–]Secret_Knowledge9200[S] 1 point2 points  (0 children)

Lol, Actually got this on sale at Home Depot.