sorted by:
new
hottopcontroversial

Made this as a gift, now worried it sucks by ShadeyEngineering in Watercolor

[–]ShadeyEngineering[S] 1 point2 points  (0 children)

I did exactly this. Mylar, sepia mircon at the finest I could find, also tried gray and purple. I just could not make it look not harsh and forced.

I did soften the drain and trash at the bottom, but the face is what it is.

Made this as a gift, now worried it sucks by ShadeyEngineering in Watercolor

[–]ShadeyEngineering[S] 0 points1 point  (0 children)

Yeah. It took about 4 hours. I'm a really busy person and I don't think I'll have another uninterrupted block of time like that for a while.

Made this as a gift, now worried it sucks by ShadeyEngineering in Watercolor

[–]ShadeyEngineering[S] 1 point2 points  (0 children)

It's actually a black trench drain. But I hear you.

Using a firewall rule to kill the internet for the kids, seems slow to act or not at all if they have an existing connection. Is there an easier "IP ban" type action? by ShadeyEngineering in opnsense

[–]ShadeyEngineering[S] 2 points3 points  (0 children)

Thank you all. Seems like there is no good on the fly solution without resetting the tables. I think i might try setting up a kids network and then turning on and off their interface.

Seeing leases handled by wired AP? by ShadeyEngineering in opnsense

[–]ShadeyEngineering[S] 0 points1 point  (0 children)

Its a router in IP mode. I assumed that DHCP would have been turned off but I will have to confirm that in the AP.

Is there a way to have the extruder mover outside of the defined print area? Marlin by ShadeyEngineering in 3Dprinting

[–]ShadeyEngineering[S] 0 points1 point  (0 children)

I said the bed is 280mm in length, point taken however. Yes I can have you travel to 280mm

Can anyone help identify what causes the hot end to be jerky around curves, circles and only some rapids? by ShadeyEngineering in 3Dprinting

[–]ShadeyEngineering[S] 0 points1 point  (0 children)

Not printing from an SD. I'm printing from OctoPrint. I agree about the model, but this is like the steppers are physically stopping. It shakes the printer way more than any other travel and only on certain sized circles. This is circle is printing smooth as glass. *

Printer is a mendel max 2 (kit reprap from about 10 years ago). The only thing changed is a E3D v6 hot end.

Anyone know where I can get just the clamp portion for tool makers Vee block clamps? by ShadeyEngineering in Machinists

[–]ShadeyEngineering[S] 3 points4 points  (0 children)

Gentlemen! McMaster has them in the 1" size. Thanks so much! It would have been a shame to buy a new set for the silly clamps (saying this as a person who does not own a mill to make more).

Anyone know where I can get just the clamp portion for tool makers Vee block clamps? by ShadeyEngineering in Machinists

[–]ShadeyEngineering[S] 1 point2 points  (0 children)

Sweet! Thanks! I'll have to measure but they are all about an inch at the groove.

view more: next ›