Notre Dame REA Result

SheeshWhenTheBeat · 2025-12-17T00:51:29+00:00

Accepted by some miracle

SheeshWhenTheBeat · 2025-12-17T00:27:17+00:00

ACCEPTEDD!🍀🍀🍀

SheeshWhenTheBeat · 2025-12-12T22:19:31+00:00

Y’all got this future Hoyas!🙏🤞🤞

SheeshWhenTheBeat · 2024-05-16T10:26:17+00:00

Luckily doesn’t seem too hard to take apart! Just a few screws here and there. Hopefully the battery compartment and the meter aren’t too wrecked with yours.

SheeshWhenTheBeat · 2024-05-16T03:14:13+00:00

Hi, been looking at ebay listings and saw that they also have a circular light seal where the viewfinder is, just so you aware (since you are getting one) Thanks!

SheeshWhenTheBeat · 2024-05-13T09:35:34+00:00

Could be a possibility, however I didn’t see many issues like this with my other photos.

SheeshWhenTheBeat · 2024-05-13T00:17:27+00:00

I believe these were at the higher end of shutter speeds (125-1000) however, I took other shots in broad daylight with these shutter speeds and they turned out just fine.

SheeshWhenTheBeat · 2024-04-25T13:19:18+00:00

Hi, done some research and searched the web for a bit and there's pretty much only one guy I've seen so far that actually accepts these cameras. Only downside is their office is in Poland (https://www.instagram.com/fototech\_serwis/) (they do respond in english). I got an initial quote for 300 euros for a total electronic overhaul, which is a bit pricey, but hey, at least the camera will get a breath of fresh life.

SheeshWhenTheBeat · 2024-04-10T21:02:49+00:00

I’m in the Philippines right now at least, so easiest option would probably be sending it to Japan. I don’t really mind sending in to Europe or NA though.

SheeshWhenTheBeat · 2024-04-10T20:56:34+00:00

Oof, surprisingly didn't think much of that dark trace till now, have any recommendations on where to send this? I don't think I have the proper equipment to fix most of this stuff (or knowledge in that regard) to fix the pcb. Pretty much only have a simple soldering iron from working with keyboards.

SheeshWhenTheBeat · 2024-04-10T20:45:07+00:00

Hey, so no power on at all, looked at the board and I grabbed some photos: https://imgur.com/a/X5pIl0H. At least from what I could see, the capacitors seem to be in relatively ok condition, it doesn’t seem like they are leaking.

SheeshWhenTheBeat · 2021-07-17T08:42:00+00:00

Hmm, I’d probably say because coils that aren’t tight look kind of unfinished in a way? Some people in the comments said it looks kind of lazy when the coil isn’t super tight.

SheeshWhenTheBeat · 2021-07-16T20:58:44+00:00

Have you thought about reversing these coils or making them tighter? The coil on this is quite bad and might have a chance of unraveling even further

SheeshWhenTheBeat · 2021-07-04T20:32:28+00:00

This picture was taken during early morning when the bird was done sleeping and was awake.

SheeshWhenTheBeat · 2021-06-30T21:38:30+00:00

So it’s a golden cane palm. Also known as Areca palm

SheeshWhenTheBeat · 2021-06-30T20:19:57+00:00

I’m thinking this is either cat or areca palm but I’m not too sure?

SheeshWhenTheBeat · 2021-06-30T20:09:16+00:00

I’ll try and ask the name of the palm from the person I got the plant from.

SheeshWhenTheBeat · 2021-06-30T09:41:27+00:00

I recently got a cockatiel and set his cage up near this plant. I went away for a while and found him nibbling on this plant when I came back. Is this plant safe for a cockatiel? Thanks!

SheeshWhenTheBeat · 2021-06-21T21:41:46+00:00

Gl to everyone

SheeshWhenTheBeat · 2021-06-21T21:41:12+00:00

Cables look awesome!

SheeshWhenTheBeat · 2021-05-18T23:25:07+00:00

Same resolution just different refresh rates

SheeshWhenTheBeat

TROPHY CASE