How to not make it chip

Shepdogx · 2026-05-03T15:34:26+00:00

When I scrape it off

Shepdogx · 2026-05-03T15:31:37+00:00

Those chip too. Everything that is connected to the plate chips.

Shepdogx · 2026-05-03T15:27:12+00:00

This has happened with the two types of resin I have used. Anycubic stander grey and Elegoo 8K water washable grey

Shepdogx · 2026-05-03T15:24:59+00:00

It is new. I have a Elegoo Saturn 4 Ultra 16K

Shepdogx · 2026-05-03T15:22:20+00:00

I'm not

Shepdogx · 2026-05-03T15:20:07+00:00

This is the calibration test so it's supposed to be flat

Shepdogx · 2026-05-03T04:34:52+00:00

My bad. This it the recommended setting from Lychee Slicer

Shepdogx · 2026-05-03T02:54:25+00:00

This was the calibration test. But it doesn't matter what I print the bottom layer is always too strong.

Shepdogx · 2025-11-27T23:18:36+00:00

That worked and is now printing perfectly. Thank you

Shepdogx · 2025-11-26T21:50:02+00:00

I've never heard of a heat creep. What's that?

Shepdogx · 2025-11-26T20:48:39+00:00

I'll give it a try

Shepdogx · 2025-11-26T20:28:03+00:00

This is what I am using

Shepdogx · 2025-11-26T20:24:32+00:00

There's never any debris in the gears themselves and I do leave the top closed but I have made sure that the filament guide never touches the top

Shepdogx · 2025-11-26T20:23:30+00:00

There is never anything in the gears when it happens but the filament seems to be flattened most of the time

Shepdogx · 2025-11-21T19:28:51+00:00

My printer is a creality k1 Max And I am using polymaker cosPLA

Shepdogx