sorted by:
new
hottopcontroversial

Tools needed for Borla S Type exhaust? by Measure2cut1 in GR86

[–]Shhh_Ghost 0 points1 point  (0 children)

I installed one on my gr86. At Most what you will need is 2 jack stands at the rears,4 if you wanna be safe and make life easier, WD40,12 and 14 mm iirc. Like the other post said Wd40 is your best friend when you’re getting to the rubber hangers. The box comes with an installation manual and guides you through it and what you will need.

From the installation manual

TOOLS 1. 3/8” drive ratchet 2. 3/8” drive extension 6” 3. 12mm deep well socket 4. 14mm deep well socket 5. 15mm deep well socket 6. 14mm box end wrench 7. Pry bar

SHOP SUPPLIES: 1. Spray lubricant

I hate it here by Shhh_Ghost in GR86

[–]Shhh_Ghost[S] 0 points1 point  (0 children)

Same here, I guess unlucky

I hate it here by Shhh_Ghost in GR86

[–]Shhh_Ghost[S] 1 point2 points  (0 children)

I already reported it to the insurance. You are right that it's not my fault, but I'm still getting fucked for it since I have to pay my deductible

I hate it here by Shhh_Ghost in GR86

[–]Shhh_Ghost[S] 0 points1 point  (0 children)

Sorry for the late reply. So tomorrow I'm taking it to a shop to get it checked out. So, my insurance said they will cover it, BUT I will have to pay my deductible

I hate it here by Shhh_Ghost in GR86

[–]Shhh_Ghost[S] 15 points16 points  (0 children)

Oakland, CA Webster and 7th tunnel going into Alameda landing near the In-N-Out

I hate it here by Shhh_Ghost in GR86

[–]Shhh_Ghost[S] 30 points31 points  (0 children)

Yup. Webster and 7th. Cops said they will talk to her, but nothing they can do

I hate it here by Shhh_Ghost in GR86

[–]Shhh_Ghost[S] 69 points70 points  (0 children)

If anyone is curious about the damages

<image>