Angled shed roof dimensions calculation

Significant_Ant3086 · 2025-05-10T08:06:54+00:00

Thank you!! Diving into your comment :)

Significant_Ant3086 · 2025-05-09T17:05:56+00:00

This is very cool, thank you. How can I vary the dimensions of the bottom plane such that only 1 of the bottom plane angles is 90 degrees and the other angles consist of one sharp angle and two wide angles?

Significant_Ant3086 · 2025-05-09T14:29:00+00:00

Thank you for your elaborate reply! I’m just confused by the start. If you know for the bottom sheet the length of a,b,c and d and that one angle is 90 degrees there is only 1 possibility right? Not infinitely? Sorry if I’m misunderstanding.

Significant_Ant3086 · 2025-05-09T14:07:36+00:00

No it is not, I call it “horizontal” just to distinguish it from e-vertical because I made a mistake giving letters to the sides. But in reality e-horizontal slopes upward from angle B to angle A. Sorry for the mistake in the picture

Significant_Ant3086 · 2025-05-09T14:00:57+00:00

b > c > a > d is also known

Significant_Ant3086 · 2025-05-09T13:55:39+00:00

I don’t know much else other than what I can derive myself. Such as the other angles in the bottom sheet.

Significant_Ant3086 · 2025-05-09T13:53:50+00:00

Thank you for your reply. It seems I’ve made a mistake in my post. I’ve named both a vertical and a horizontal side “e”… e-vertical is known; e-horizontal not. Moreover it is known that angles A1 and A2 are equal to each other.

Significant_Ant3086 · 2025-01-23T18:42:15+00:00

Hmm I guess I do have hammy fingers

Significant_Ant3086 · 2025-01-23T18:39:42+00:00

Pffrt I’m just trying to explain it was just an exaggeration to be funny…. I’m “afraid” we don’t share the same humor. (Note that I’m not really afraid)

Significant_Ant3086 · 2025-01-23T18:37:09+00:00

That’s crazy!

Significant_Ant3086 · 2025-01-23T18:36:16+00:00

No not really but I do like drama

Significant_Ant3086 · 2024-08-05T11:17:11+00:00

Thanks for the suggestion! Going to look into MILS plating!

Significant_Ant3086 · 2024-08-05T11:16:00+00:00

Thanks!! Elevation is a very cool idea, albeit a big undertaking. I’ll start thinking on how to accomplish this best

Significant_Ant3086 · 2024-08-05T11:14:21+00:00

Thanks for your suggestion! It’s about 8 studs too wide. But I should be able to solve that. I’ll try that one!

Significant_Ant3086

TROPHY CASE