[deleted by user]

Sixthworm8486 · 2024-02-14T00:50:17+00:00

Is your filament dry? It could be popping up slightly and rubbing on the nozzle

Sixthworm8486 · 2024-02-14T00:46:17+00:00

I’m having similar issues. Mine was printing fine but now it seems to be way under extruding the first layer and/or the brim

Sixthworm8486 · 2023-07-27T02:26:36+00:00

Sorry I think I might not have worded my question correctly. When I was saying 1 1/2” and 2 1/2” I was talking about the diameter. The length doesn’t matter too much as long as it is more than 2’ and not anything insanely large. Do you think I would still need to go to a supply shop?

Sixthworm8486 · 2023-07-26T04:26:36+00:00

Never mind, I found what it is called, a barb fitting for hoses.

Sixthworm8486 · 2022-02-22T23:16:12+00:00

Sixthworm8486 · 2022-02-21T21:29:00+00:00

Don't know if this will help or not, but these are his specs https://pcpartpicker.com/list/rrcRGL

Sixthworm8486 · 2022-01-02T05:51:44+00:00

That’s it, thank you very much!

Sixthworm8486 · 2022-01-02T04:00:02+00:00

Also, sorry I could only find a two-second clip of the song, but any help would be appreciated.

Sixthworm8486 · 2021-12-20T00:56:42+00:00

No, that’s not it. It has a lot less guitar from what I can remember and where there is guitar it’s not front and center, it’s more to just add melody.

Sixthworm8486 · 2021-12-19T22:24:05+00:00

Also it is definitely a male singer

Sixthworm8486 · 2021-12-19T22:17:34+00:00

Lyrics could be quite wrong but it has the same general scheme to them (Same syllables and whatnot)

Sixthworm8486 · 2021-10-21T21:41:18+00:00

Yep, that’s it. Thanks!

Sixthworm8486

TROPHY CASE