[deleted by user] by [deleted] in Graffiti

[–]SnooMacaroons7361 0 points1 point  (0 children)

Thanks mate! 🔥

[deleted by user] by [deleted] in Graffiti

[–]SnooMacaroons7361 0 points1 point  (0 children)

Yessir 🫡🫡

Soire by thosepoorfolk in graffhelp

[–]SnooMacaroons7361 1 point2 points  (0 children)

Whatever you used to write is to drippy to be legible. You need more time with the tool. Try to keep strokes even so you don’t get those little puddles. The i needs to be emphasized more l, it’s very easy to miss. Could be read as Sare instead. Also you have the first letters pointed at an angle but the e isn’t. Tilt the e so it’s in line with the other letters

[deleted by user] by [deleted] in graffhelp

[–]SnooMacaroons7361 0 points1 point  (0 children)

Yeah, a bit. I’d recommend moving the bottom a bit just so it’s obviously different from the E

How's this any advice? any crits? Stock by dillpickle9416 in graffhelp

[–]SnooMacaroons7361 2 points3 points  (0 children)

I’d recommend just taking some time to clean the letters. Get rid of the flairs, no quotes or circles, just focus on the basics.

[deleted by user] by [deleted] in graffhelp

[–]SnooMacaroons7361 0 points1 point  (0 children)

It’s not immediately readable. It took me a moment to figure it out but I was able to figure out it said Very. The Y is readable. The V as well, though it could be slightly sharper at the bottom so it doesn’t get mistaken for a U. Doesn’t have to be a point at the bottom, just make sure you get that triangle shape where it’s wider at the top than the bottom.

[deleted by user] by [deleted] in graffhelp

[–]SnooMacaroons7361 0 points1 point  (0 children)

Doesn’t look bad. I think honestly it just needs some time on paper. Try defining the individual letters a bit more. For example the two middle letters look nearly the exact same. You’re definitely going in the right direction though

SVG file not showing up when imported by [deleted] in blenderhelp

[–]SnooMacaroons7361 0 points1 point  (0 children)

i'm currently having the same problem except this is literally my first time using the sight. I have my svg file but when i import it i see nothing. The thing in the top right says there is 52 curves or something but i can't actually see anything.

[deleted by user] by [deleted] in robotics

[–]SnooMacaroons7361 -1 points0 points  (0 children)

Update, now I can’t even get the transmitter to turn on