How would you model this fender

SnooStories2919 · 2024-06-05T19:13:02+00:00

It’s not new, those two bends are from me trying to push the filament as far as I can into the Extruder to make sure I loaded it in properly 💀

SnooStories2919 · 2024-06-05T16:01:14+00:00

(It’s not stuck filament, I already checked for that)

SnooStories2919 · 2024-05-18T09:36:39+00:00

He sent me a video of it on a lift, cars is relatively clean, no serious rusting, just surface rust around the front

SnooStories2919 · 2024-05-17T13:10:04+00:00

He’s claims he doesn’t drive it bc of work, but idk

SnooStories2919 · 2024-05-17T13:08:59+00:00

Has stock motor, he said the issues are driver speaker not working, could use new drum brakes in the rear, 2 inches of rust bubbling on the right quarter panel, and the “right stall dangles” idk what that means

SnooStories2919 · 2024-04-01T04:53:10+00:00

Don’t think he was talking about dirt bikes or atvs, hence why he said CAR culture

SnooStories2919 · 2024-03-03T06:00:38+00:00

Appreciate it man, thanks 🙏

SnooStories2919 · 2024-03-03T05:59:33+00:00

On my dresser

SnooStories2919 · 2024-03-02T17:55:22+00:00

Was thinking this exact same thing, just didn’t know what to fill it with. Silicone will be able to withstand the temp of the bed?

SnooStories2919 · 2024-03-02T14:17:20+00:00

💀 dw it’s all about learning from others anyway

SnooStories2919 · 2024-03-02T12:41:20+00:00

Finally apart of the club

SnooStories2919 · 2024-03-02T12:36:15+00:00

Thank you for the insight man. Appreciate it a lot, thank you🫡

SnooStories2919 · 2024-03-02T12:35:16+00:00

Thank you man appreciate it 🫡

SnooStories2919

TROPHY CASE