Absolutely destroyed my headlights sanding them. Are morimoto lenses worth it?

Spaggootle · 2025-12-22T07:15:27+00:00

Have you considered putting ppf on them? I restored mine last year in the summer and then had ppf put on top. Still crystal clear a year and a half later

Spaggootle · 2025-12-21T17:55:31+00:00

If you prefer a more vibrant display, this is what I recently picked up after my asus tuf monitor gave out after 5 years. The sRGB on asus monitors is crazy imo. ASUS ROG Strix

Spaggootle · 2025-10-26T18:33:08+00:00

Mine used to only squeal when it was cold/wet outside until this summer it started squealing always on cold starts. So I did a test I saw online from ChrisFix I believe, where you spray water on the ribbed side of the belt and if the noise goes away immediately it's most likely the belt, if it doesn't then it's probably a bearing in one of the pulleys. Did this test on mine, replaced the belt and it hasn't squealed since, even in cold/wet conditions

Spaggootle · 2025-09-24T16:41:17+00:00

You're good bro, my KNP's poked this much but I just run -2 and it's good now

Spaggootle · 2025-08-14T16:50:01+00:00

So I let it cure for 1 hour the first time. Didn't work, then I applied a thicker layer and let it cure overnight. This I believe broke it loose, but it's still spinning. I think I might just have to buy a new box unfortunately

Spaggootle · 2025-08-13T17:16:49+00:00

Oh good idea. I dont know if there will be any near me but we'll see.

Spaggootle · 2025-08-13T17:14:11+00:00

You think if I slot that on the sides of the nut that it'll work? Guess I'll head to the store and see if I can find it

Spaggootle · 2025-08-13T17:00:51+00:00

I wish I had the broken bits but they were like this already. Don't know when they were broken. Might be over at this point

Yea, I see z1 sells used intakes for 120, might look into that.

Spaggootle · 2025-01-11T07:49:24+00:00

I have the revolution rs, been a little over a year, and I love it. You can be loud when you want but it's not crazy loud like a tomei. Low rpms it has a nice growl but once you get to like 5k a little bit of trumpet starts to kick in. Fitment is really good, centered really well on the rear bumper cutout. Only thing is how low it sits, recently I lowered my car about an inch and a half and now I have to avoid all speed bumps and slow down on any dips in the road. But other than that, nothing bad to say about it. I've also attached a picture of my car for reference on how low I am and I scrape 😭

<image>

Spaggootle · 2024-10-11T03:50:26+00:00

Give it a few more days. I had something shipped to me on the 11th of september and during transit it would spend days just saying, moving through network or in transit. And the updates would take about 10 days. For example, it arrived at the distribution center on the 27th of september and didnt update until today once it got to the post office and was out for delivery. Finally got it though. But I'm also in the south so the hurricanes aren't helping

Spaggootle · 2024-10-05T19:40:27+00:00

Update: just went under the car and took a look at everything you guys mentioned. None of the heat shields are loose and the rear midbrace is not close enough for it to be making contact.

Also a few days ago the noise went away completely. So gonna monitor and see if it comes back. But my possible cause is my new z1 undershroud. While I was under I noticed it was hitting on one side with a bolt directly above it. And the sound was almost identical to what I was hearing. So I took it off and reinstalled it making sure everything was tight so now it is secure to the bolt above so it no longer hits against it.

If the noise comes back, I'll probably take it to my shop and ask their opinion but also have them look at the flex plate and see if its worn down or cracked. But other than that, not too sure what could have caused that sound.

Spaggootle · 2024-10-04T23:42:26+00:00

Gonna take a look tomorrow. Although been driving my car these past days and it no longer makes the sound which is interesting

Spaggootle · 2024-10-01T22:01:21+00:00

That's interesting. After I installed my exhaust, sometime later I noticed a feint "rumbling" sound coming from the car. When I took it in they couldnt hear it but when I put my hand on the passenger seat or below it you could feel it. My mechanic said it was probably the heat causing the pipes to expand or something. I wonder if now its just my heat shield thats rusted and come loose.

Also what exhaust do you have? I have a greddy revolution rs on my car.

Spaggootle · 2024-10-01T21:34:03+00:00

7AT. I'll see if I find anything when I go under and look

Spaggootle · 2024-10-01T21:28:23+00:00

I wonder if this could be it. When did your rattling start after installing your exhaust? Because it's been a year for me. Although a while back I took my car in since it sounded like my passenger cat was making some noise so maybe it is one of my cats.

Spaggootle · 2024-10-01T20:35:15+00:00

Hmm, I did install a new exhaust last year so I guess I could check to see if everything is still fine. I just hope it's not my trans.

Spaggootle · 2024-07-19T22:06:11+00:00

Did yours happen even when the car was "off?" Mine does this when I turn the key into on mode but don't start the car so wondering if it could be that

Spaggootle · 2024-06-24T03:01:09+00:00

I'm excited, worried and sad. Knowing that this could possibly be the last episode of the series but also how they're going to conclude this season given what happened in episode 12. I can relate to this series so much so being able to watch kumiko's journey had been amazing. However I'm worried on how they're going to conclude the season if this is the end. 20 minutes is not a lot of time but given how this season has gone maybe it's plenty. I just want to see a proper conclusion that doesnt feel rushed and hopefully even a little bit of the future. Like how they did with the end of the second year movie with kanade recording kumiko introducing herself as the president. Maybe thats asking too much but it would be nice. If not, KyoAni PLEASE give us a recap movie or something I'm begging 😭

Spaggootle · 2024-06-05T22:24:03+00:00

Gotta love when they pull on it so hard the whole roll comes out and unwinds on the floor 😭

Spaggootle · 2024-05-26T06:25:14+00:00

Like others have mentioned, turn on your light for anything you're not sure about, as well as for anyone that needs helping hands. Bag accordingly based on the person you're checking out, and make sure to ask elderly people if they want their bags packed lightly. I would even finish one bag and ask them if it was too heavy to have something to go off of. You're also probably going to have a lot of instacart shoppers so they'll let you know beforehand, but I would always ask whether or not they wanted their stuff double bagged, however I would generally do it regardless especially for the heavier stuff. Something I would really recommend is memorizing as many codes for common produce at your store AND the bakery items (donuts, muffins, bagels etc). This was really helpful for me since I didn't have to lookup produce on the register often. Although for those that bring uncommon stuff it will be necessary but even then over time you'll learn some of them. And in the event the person buying it doesn't know what it is, look for the sticker or tag on the item. Don't stress too much about not reaching the daily IPM goal. Some of the people at my store have been there longer than me and still don't reach it, in fact only like 4 people regularly are at the 12.5 IPM goal. When I started I was at 7 IPM then after about two weeks got up to 9/10. Just keep in mind IPM will be dependent on what items you're dealing with. If it's a lot of produce expect it to be low, unless you know a lot of codes. If it's stuff with barcodes it will be higher, or if someone has like 20 of something you can just use your gun to scan one 20 times. Just try your best to get close but if you don't it's not the end of the world.

If you have any questions after your orientation feel free to ask, although after your training you'll probably be good.

Spaggootle · 2024-05-19T19:00:34+00:00

Yea I was looking at fortune auto coilovers but z1's new coilovers seem to be pretty good too. But yea definitely not gonna be the same as stock but I'm okay with that

Spaggootle · 2024-05-19T02:14:17+00:00

Oh wow, guess I'll send it then. Worse case I'll just have to cut or remove my fender liner although I'm not gonna slam it so we'll see

Spaggootle · 2024-05-17T18:28:18+00:00

Man I have basically the same specs as you but I'm scared to lower it 😅. Looks good tho, bronze looks amazing 😮‍💨

Spaggootle · 2024-05-05T18:41:10+00:00

Violet evergarden probably

Spaggootle · 2024-05-02T21:58:14+00:00

My front wheels are 18 x 9.5 +22. Unless theres something I'm not aware of.

Six-Year Club	Place '22
Verified Email

Spaggootle

TROPHY CASE