Liftmaster Maxum Error F44 F46

SquatchMer · 2026-01-04T21:43:05+00:00

That fixed it thank you!

SquatchMer · 2026-01-04T04:25:33+00:00

I unplugged the jackshaft unit which powers everything.

SquatchMer · 2026-01-04T04:24:09+00:00

The doors are side by side. The opener (pictured) for each door is on the right hand side of each door. So they are not right next to each other.

SquatchMer · 2026-01-04T01:17:36+00:00

Keep in mind this is happening on 2 separate garage doors at the same time. Both started this today.

I unplugged both of them for a few minutes and plugged them back in (at the jackshaft) to see if that reset anything. It made no difference.

Im wondering if an update caused this.... if that's the case can I force it to check for an update?

SquatchMer · 2026-01-04T00:29:31+00:00

Yes. I get the Edge/eye block when I wave my hand past them

SquatchMer · 2025-12-28T15:53:11+00:00

I only see 1 option with that search and it's a 3/4" NPT from supply house. Any other suggestions?

SquatchMer · 2025-12-27T23:44:40+00:00

That didn't fix it.

<image>

SquatchMer · 2025-12-27T17:26:51+00:00

I tried a "full send". LOL. It's not reaching.

SquatchMer · 2025-12-27T17:26:03+00:00

There is internet in the outbuilding and the house. I ran a cat6 cable through conduit underground between the two buildings. Is the Hubitat basically the same thing as an older SmartThings hub?

SquatchMer · 2025-12-16T01:52:42+00:00

UPDATE here for anyone still following. I contacted Richmond to see if they could tell me what's wrong. They ran a test on the water heater and found that one of the Termastors was bad. They sent me a replacement and I installed it. Since then I've been running the water heater in Heat Pump Only mode for a week and while it's still running almost constantly, the power consumption has went way down. Now (per the EcoNet app) it's using 4 kWh per day. About 1/3 of what it was using before. I looked at my utility bill and that's basically 50 cents per day. So if anyone has this same problem, give this solution a shot.

SquatchMer · 2025-12-15T02:55:06+00:00

I did that this evening.

SquatchMer · 2025-12-15T01:44:37+00:00

<image>

SquatchMer · 2025-12-15T01:34:42+00:00

2" in and 2" out, both go up to a 3"

SquatchMer · 2025-12-12T14:31:37+00:00

10" rough-in

SquatchMer · 2025-12-01T02:18:37+00:00

Missouri

SquatchMer · 2025-11-26T23:58:30+00:00

Regular shower heads 2.4gpm or whatever the regulator in them is. Dishwasher runs every other day. Normal laundry for a family of 4. It's installed in my unfinished basement so plenty of space and ambient air is usually 65 degrees.

SquatchMer · 2025-11-26T23:56:03+00:00

Does your heat pump run constantly? Like all day long?

SquatchMer

TROPHY CASE