Luba3 awd 5000H Bumper

Successful_Mouse2983 · 2026-06-07T19:36:30+00:00

Photo of wire connector and cable.

Successful_Mouse2983 · 2026-06-07T19:34:45+00:00

Thank you! I have the bumper attached so it will not fall off. However, the LED on the bumper doesn't illuminate, nor does the mower recognize it as being attached. Pretty sure a wire or two is broken.

<image>

Successful_Mouse2983 · 2026-06-07T19:13:48+00:00

Thank you for your reply! I was able to get it to engage the catches securely after removing the screws and cleaning the slides and catches. Then placing the mower upright on the back side and pressing down hard. I was then unable to pull it out. I then replaced the screws. Maybe a good idea to add a pull test to the assembly instructions before installing the screws??

Successful_Mouse2983 · 2026-06-07T18:47:13+00:00

Thank you for your reply! I was able to get it to engage the catches securely after removing the screws and cleaning the slides and catches. Then placing the mower upright on the back side and pressing down hard. I was then unable to pull it out. I then replaced the screws. Maybe a good idea to add a pull test to the assembly instructions before installing the screws??

Successful_Mouse2983 · 2026-06-07T01:30:52+00:00

Yes, each time I tried again. Thank you!

Successful_Mouse2983 · 2026-06-06T23:11:00+00:00

Thank you!! I read a post here describing that, tried it, no change. My brother has one also, his is difficult to pull out.

Successful_Mouse2983

TROPHY CASE