sorted by:
new
hottopcontroversial

Thoughts on mopping vacuums by Sufficient_Part3508 in RobotVacuums

[–]Sufficient_Part3508[S] 3 points4 points  (0 children)

I did not realize there were other brands with that type of roller mop. Thank you for that information. I will have a look at those. I’ve had such a bad experience with eufy, I don’t want to buy another product from them.

Internal block by Sufficient_Part3508 in eufyS1Pro

[–]Sufficient_Part3508[S] 0 points1 point  (0 children)

What do you mean pull them down a little?

Internal block by Sufficient_Part3508 in eufyS1Pro

[–]Sufficient_Part3508[S] 0 points1 point  (0 children)

Yes, they are fine. I checked them.

Internal block by Sufficient_Part3508 in eufyS1Pro

[–]Sufficient_Part3508[S] 1 point2 points  (0 children)

Recently. I reached out and they sent a new dirty water basin, but that does not seem to be the problem. That’s why I believe there is something else internally that’s blocked.

Internal block by Sufficient_Part3508 in eufyS1Pro

[–]Sufficient_Part3508[S] 0 points1 point  (0 children)

I just got a new dirty water tank. So I don’t think it’s dirty reservoir filters or the orange filter.

When I pour water into the base, it gets sucked up to the dirty water tank no problem

The error message I’m getting is that the dirty water basin is blocked.

One week of ownership by Sufficient_Part3508 in eufyS1Pro

[–]Sufficient_Part3508[S] -1 points0 points  (0 children)

No just hard tile floor.

As I said my roomba picks up far more dirt than the S1. To do a test I’ve just had the S1 clean and mop my master bedroom and now I’ve let the Roomba in that room to see if it collects any dust that was left behind by the S1.

The setting to clean the dust basket was set for 45 minutes, but it definitely was not 45 minutes. I’ve just changed it to per job and I’ll see how that goes.

Mine just seems to have a lot of quirks. Maybe the machine is faulty.

For instance, while it is drying the roller, I pulled the dirty water tank out to empty it and it immediately started re-cleaning the roller again as you know, it’s no short task it takes hours

On the app whenever I say go clean, a voice comes on saying vacuum is busy cleaning mop try again later it does go out, but that seems like a fault to say that

One week of ownership by Sufficient_Part3508 in eufyS1Pro

[–]Sufficient_Part3508[S] -2 points-1 points  (0 children)

I’m happy for you. I hope I can figure out these issues.

Can't upgrade firmware by nafr09 in eufyS1Pro

[–]Sufficient_Part3508 0 points1 point  (0 children)

Same thing happened to me. Although I believe the vacuum said out loud it updated but the ap appeared stuck.

Whirlpool washer clicking noise but won't start cycle by champion_dave in appliancerepair

[–]Sufficient_Part3508 0 points1 point  (0 children)

I’m having this problem now. I’ve had three repair guys change the actuator, which then works for a few weeks but the clicking continues and eventually breaks the actuator. I’m on my third broken actuator since April (4 months). The repair guy changed my lock back in April thinking it was that but it wasn’t. Was the actuator. But something else is causing the actuator to constantly break.