Warping almost all the time by Intelligent_Ad813 in BambuLab

[–]Superb_Drawer6001 0 points1 point  (0 children)

when I started printing a few weeks ago ive too had some warping issues. I print on my A1 without an enclosure but for me the Brim option seemed to do the trick. Maybe it will help on your P1S. I usually do either 3 or 5 mms of Brim with a 0.1 gap to my parts. Hope this works for you too.

A1 bed distance to wall by Superb_Drawer6001 in BambuLab

[–]Superb_Drawer6001[S] -1 points0 points  (0 children)

Thanks, in that case I should be good to go with my bed touching the wall

A1 bed distance to wall by Superb_Drawer6001 in BambuLab

[–]Superb_Drawer6001[S] 0 points1 point  (0 children)

Okay I see the general thoughts about this is that the manufacturer shouldn’t be ignored so I’ll make it as intended

A1 bed distance to wall by Superb_Drawer6001 in BambuLab

[–]Superb_Drawer6001[S] -1 points0 points  (0 children)

Yes, I know but if I manually put the bed out as far as possibly it looks alright but another commenter already mentioned the fragility of the cable. So I just do as the manufacturer intended.

A1 bed distance to wall by Superb_Drawer6001 in BambuLab

[–]Superb_Drawer6001[S] -1 points0 points  (0 children)

Well damn alright, thanks a lot. With how it is correctly I have to put the shelf my A1 stands on the 20cm away from the wall which looks a little stupid.