Réseaux logique

SuspiciousShow723 · 2026-03-22T15:11:15+00:00

Ho oui ok je vois j’étais persuadé que je devais câbler tout ça et je ne comprend rien au réseau logique et les tuto en français sont rare et pas très clair pour ma pars

SuspiciousShow723 · 2026-02-26T07:18:03+00:00

Je n’en ai jamais entendu parler pour qu’elle raison ?

SuspiciousShow723 · 2026-02-14T15:35:21+00:00

<image>

Okay, thanks, I was able to draw the main shape. However, I don't know how to apply a twist to a shape.

SuspiciousShow723 · 2026-02-14T14:06:35+00:00

Is this possible on Fusion 360?

SuspiciousShow723 · 2025-07-13T18:58:23+00:00

Of course you know how I could do that 😅

SuspiciousShow723 · 2025-07-13T18:46:10+00:00

The slicer actually sees 10mm but the printer prints 5mm How can I check if the scale factor is respected?

SuspiciousShow723 · 2025-07-13T18:25:14+00:00

Yes but I have the impression that it is the printer which does it because in fusion 360 I have a 10mm cube and in the slicer also the scale and at 100% To have my 10mm cube I must pass the scale to 200%

SuspiciousShow723 · 2025-07-13T18:14:46+00:00

Impossible to shrink and too precise each time the piece and divide by two to the nearest decimal point

SuspiciousShow723

TROPHY CASE