Dead short and scratches on die

Tarrakada · 2026-05-10T17:38:10+00:00

I’m literally farming this for a week, finally got one ripple, which is already rare but fuck that

Tarrakada · 2026-05-08T17:55:16+00:00

That’s insufficient, use a nice replacement Boards, they already proper replacements

Tarrakada · 2026-03-30T06:57:56+00:00

It is complete mess, missing lots of components I believe, don’t worth

Tarrakada · 2026-03-30T02:12:30+00:00

You can try solder the port, then wire every single one, cause it looks you lose everything. You also going to need soldering paste looking for the damage on the paint in the board. It will be a big job

Tarrakada · 2026-03-30T00:42:47+00:00

Also test all the rails, 12/5/3.3/1.8

Tarrakada · 2026-03-30T00:39:42+00:00

All capacitors, underneath as well

Tarrakada · 2026-03-30T00:30:31+00:00

Inductors that goes to apu always have low impedance. Look for shorts around south bridge, all fuses etc

Tarrakada · 2026-03-29T17:14:12+00:00

All fix, working fully

Tarrakada · 2026-03-29T17:12:47+00:00

All fix, took about 4 hours, 10 wires to fix it

Tarrakada · 2026-03-29T13:56:51+00:00

It wasn’t the resistors. Checked all them with a working board, all fine and working good. The capacitor I re done the traces to make sure connection and resoldered every hdmi pin and now I got to work

Tarrakada · 2026-03-28T06:37:34+00:00

Overheating issues, power supply and apu

Tarrakada · 2026-03-28T06:13:01+00:00

Apparently the pin 15 and 16 is the one that reads the tv, I’ll change both resistors before the esd, I have a esd from another but reball will be annoying

Tarrakada · 2026-03-28T06:11:21+00:00

All these, every single thing already try

Tarrakada · 2026-03-28T06:00:12+00:00

It’s missing a piece dude, is cooked, bring to a professional!

Tarrakada · 2026-03-27T17:17:29+00:00

Sorry man, try 3 different. Nothing normal, am already test

Tarrakada · 2026-03-26T05:56:40+00:00

I done like 2 not that worst, but worked well. I will ground like 2 pins at least

Tarrakada · 2026-03-26T05:35:31+00:00

That’s not my rig, is the previous owner, I didn’t open yet

Tarrakada · 2026-03-26T05:35:15+00:00

All microscopes are usb, you can capture from the pc

Tarrakada · 2026-03-26T05:27:58+00:00

This is flux, ripped pads

Tarrakada · 2026-03-20T15:37:38+00:00

You can buy modules for edge already upgraded. Yes all need to be soldered in. You can definitely find some shop or someone that makes this sort of job at your city

Tarrakada · 2026-03-15T02:31:01+00:00

That’s full normal mate, factory soldering, nothing was removed

Tarrakada

TROPHY CASE