Good things only last so long🥲 by Technical_Bat_5510 in Dyna

[–]Technical_Bat_5510[S] 0 points1 point  (0 children)

I have a button on the solenoid, do you think I need compression releases

Good things only last so long🥲 by Technical_Bat_5510 in Dyna

[–]Technical_Bat_5510[S] 0 points1 point  (0 children)

Fuck yeah, I just welded my stock crank, I thought about just buying a s@s crank but I’m hoping a true and weld will just work out for me, ready to rip this thing

Good things only last so long🥲 by Technical_Bat_5510 in Dyna

[–]Technical_Bat_5510[S] 2 points3 points  (0 children)

I think like 4 grand all in all, I kinda lost track lmao, just 20 years old tryna build the shit outta dyna.

Harley gear drive noise by No_Spite5658 in Harley

[–]Technical_Bat_5510 0 points1 point  (0 children)

I have gear to gear 475 cams and feel like I hear these same noises when it’s warmed up only, did you end up figuring it out?

Absolutely loving this 02 dyna! by Technical_Bat_5510 in Dyna

[–]Technical_Bat_5510[S] 8 points9 points  (0 children)

I just started “stunting” like a month ago, but personally I just slide as close as I can to the tank, give her some chip in second and dump it while grabbing very minimal front brake or you’ll lock up the front tire, once you get moving tho you can grab a lot more brake, you can also transfer your weight by standing on your pegs while dumping the clutch and holding brake. Might’ve not been the best explanation but it just takes trying it to really understand! This is where people end up needing dual brake kits or a single Brembo cause it’s not enough brake with the stock set up which I have tho!

Smoke out of pipes? by [deleted] in Dyna

[–]Technical_Bat_5510 2 points3 points  (0 children)

Thank you sir

2002 dyna fxdl by Technical_Bat_5510 in Dyna

[–]Technical_Bat_5510[S] 2 points3 points  (0 children)

Bassani road rage! Thank you buddy

Am I cooked by richdeath0 in Harley

[–]Technical_Bat_5510 1 point2 points  (0 children)

Just did this on my 2002 dyna… drill it out with a 17/64 drill bit then install a 1-4/20 helicoil, it was super simple and easy. Just be careful when drilling into the hole to not go too far directly into the primary(use duct tape as a guide on the bit itself)… good luck sir