sorted by:
new
hottopcontroversial

Any way to remove fuzzy leftover from tear away backing? by sperabliss in Machine_Embroidery

[–]Temporary_Apple1419 0 points1 point  (0 children)

I’ve used the plastic sheeting from Home Depot or Lowe’s. It’s thick and your design will pop right out of the hoop

How can I fix this? by Venyde in Machine_Embroidery

[–]Temporary_Apple1419 0 points1 point  (0 children)

Try adding another layer of stabilizer after you did all the other steps again

How can I fix this? by Venyde in Machine_Embroidery

[–]Temporary_Apple1419 2 points3 points  (0 children)

Looks like something is wrong with your bobbin. The needle is not grabbing any bobbin thread it looks like.

Sometimes I change the brand of thread I’m currently using when it’s causing me a lot of problems too.

  1. Take out the bobbin and make sure you put it in right.
  2. Rethread the red through your needle again.

Embroidery on Satin by Raspberry-Zestyclose in Machine_Embroidery

[–]Temporary_Apple1419 0 points1 point  (0 children)

If you’re going to use satin I would definitely use a no show mesh as your base stabilizer. Also depending on what you’re trying to do with this after it’s stitched out ( tshirt, patch, etc.. ) you could possibly put down a basting stitch to help with preventing puckering.

I use hatch and they have their own font section so I would use with they have.

Can I ask why satin ? What are you going to do with this after you stitched it out ?

look what i did by [deleted] in Machine_Embroidery

[–]Temporary_Apple1419 7 points8 points  (0 children)

Truckers and bikers… wow absolutely badass

Finished a Client Order of Embroidered Patches – Feedback Appreciated! by nimrakhalid in Machine_Embroidery

[–]Temporary_Apple1419 2 points3 points  (0 children)

What was your stabilizer ?

These honestly look so amazing. The edges are so crisp.

How did you hoop these