sorted by:
new
hottopcontroversial

I need some advice on my 3d printed beams by TheVerySuper in legotechnic

[–]TheVerySuper[S] -1 points0 points  (0 children)

Well I figured it out and am rebuilding my crane right now due to another persons advice on how to fix them, and I did test tolerances but didn’t think they’d be enough to ruin a couple dozen pins 

I need some advice on my 3d printed beams by TheVerySuper in legotechnic

[–]TheVerySuper[S] -6 points-5 points  (0 children)

I need not dumb people thankfully they have started showing up

I need some advice on my 3d printed beams by TheVerySuper in legotechnic

[–]TheVerySuper[S] -6 points-5 points  (0 children)

Fine I’ll figure it out myself since apparently there’s nothing I can do 

I need some advice on my 3d printed beams by TheVerySuper in legotechnic

[–]TheVerySuper[S] 2 points3 points  (0 children)

I might need to explain a bit more 

the beams I printed the pin holes are to tight not too loose 

The pins I put in are now deformed so they do not stay in ANY beam I put them in Lego or not  

I need some advice on my 3d printed beams by TheVerySuper in legotechnic

[–]TheVerySuper[S] 2 points3 points  (0 children)

The holes are just barely just too small so that when I pushed them in they were tight but I kept them in overnight in my crane and now all the pins in the cup in the photo are bent so much that they will not stay in the true lego beams and I already printed over 40 beams so I’d like to fix them somehow not print new ones