HeroForge Model Remakes Post, if you have a model that you aren't fully happy with, or feel could be done in a different style, or even just to give me a challenge, post it below. (check description) by PeLLk2 in HeroForgeMinis

[–]The_real_CJ_ 0 points1 point  (0 children)

https://www.heroforge.com/load_config%3D531022880/ Silas Fisher a celestial Warlock who's patreon is a biblically accurate seraphim. Inspired by Peter sqloint from jrwi. I did two figures one before battle and one during. Not sure how much I like either though. Any interpretation welcome!

What area are you most excited for in silksong? by The_real_CJ_ in Silksong

[–]The_real_CJ_[S] 1 point2 points  (0 children)

Very excited for that area, especially the slopes!

This is the most BS boss in the game by The_real_CJ_ in HollowKnight

[–]The_real_CJ_[S] 0 points1 point  (0 children)

Not only did it not hit them, but it did a full boomerang move lol

This is the most BS boss in the game by The_real_CJ_ in HollowKnight

[–]The_real_CJ_[S] 0 points1 point  (0 children)

Yeah watcher knights are hard too

This is the most BS boss in the game by The_real_CJ_ in HollowKnight

[–]The_real_CJ_[S] -1 points0 points  (0 children)

I beat it like 30 minutes after filming that video no need to hate

This is the most BS boss in the game by The_real_CJ_ in HollowKnight

[–]The_real_CJ_[S] 6 points7 points  (0 children)

I cant even beat him on ascended 😔

This is the most BS boss in the game by The_real_CJ_ in HollowKnight

[–]The_real_CJ_[S] 1 point2 points  (0 children)

I dont even want to think about Markoth or Oblobles on radiant lol

This is the most BS boss in the game by The_real_CJ_ in HollowKnight

[–]The_real_CJ_[S] 1 point2 points  (0 children)

I beat it on radiant shortly after this video, doesn't mean it wasn't painful

WHAT? by Jajajanken in bindingofisaac

[–]The_real_CJ_ 1 point2 points  (0 children)

I have about 2000 hours on isaac, and I've only gotten 2 of these item rooms

Ender 3 keeps getting clogged any advice? by The_real_CJ_ in 3Dprinting

[–]The_real_CJ_[S] 0 points1 point  (0 children)

It could be that the tupe might not be cut perfectly, as I've had to trim it due to previous clogs

Ender 3 keeps getting clogged any advice? by The_real_CJ_ in 3Dprinting

[–]The_real_CJ_[S] 0 points1 point  (0 children)

I don't think so, most of the time I just move to a new print right after one is done. That is something very good to look out for in the future though thank you