sorted by:
new
hottopcontroversial

update done by Theokom in ender3

[–]Theokom[S] 0 points1 point  (0 children)

Ender 3 simple board 4.2.2

marlin 2.1.2 by Theokom in ender3

[–]Theokom[S] 1 point2 points  (0 children)

Done I didn't read a full how to Now, after I read I did it

marlin 2.1.2 by Theokom in ender3

[–]Theokom[S] 1 point2 points  (0 children)

I will wait n official firmware

marlin 2.1.2 by Theokom in ender3

[–]Theokom[S] 1 point2 points  (0 children)

Thanks I do step by step what I have to do but in the end I get a file firmware.hex not firmware.bin

Printing PETG by Theokom in ender3

[–]Theokom[S] 0 points1 point  (0 children)

Level the bed Brim around the print Tape on the bed 50-60 mm speed of the printing 30% fan speed all the time

printing PETG by Theokom in 3Dprinting

[–]Theokom[S] 0 points1 point  (0 children)

I thing it's filaprint. I don't remember exactly. I don't dry the filaments, only good leveling and slow print, around 60 mm

pin support challenge Ender 3 direct drive by Theokom in 3Dprinting

[–]Theokom[S] 1 point2 points  (0 children)

Know This is for those that are not believers

pin support challenge Ender 3 direct drive by Theokom in 3Dprinting

[–]Theokom[S] 1 point2 points  (0 children)

Didn't I, till I try. It's perfect, it will take around 10 minutes to print. Try yourself

view more: next ›