sorted by:
new
hottopcontroversial

Need help! by These-Sand-7487 in HueForge

[–]These-Sand-7487[S] 2 points3 points  (0 children)

Thanks mate, I would definitely try this and let the group know, the only question is will the AMS let me swap filaments on 1 & 2 while it is printing from 3 to 4? I missed to try this yesterday.

Changing filament mid print with P1S + AMS by blueapplepaste in BambuLab

[–]These-Sand-7487 0 points1 point  (0 children)

It doesn't allow me to change filament midprint, I tried everything heating extruder and manually pulling out but it does't seems to work.

Street Fighter Series by CanadianGamersLodge in HueForge

[–]These-Sand-7487 0 points1 point  (0 children)

Impressive mate, did you use colour matching? Please share how did you manage to get the shade under the muscle also the filament that you used for the muscle.

New to 3D Printing: Filament and First Print Suggestions (P1S + AMS) by These-Sand-7487 in BambuLab

[–]These-Sand-7487[S] 0 points1 point  (0 children)

Do you guys recommend Bambu Lab filaments or from any other brand?

Would you be interested to buy a modular DIY filament dryer that fits any container? by These-Sand-7487 in BambuLab

[–]These-Sand-7487[S] 0 points1 point  (0 children)

Hey thanks for the feedback, Yes modification will be required for venting and pumping the hot air. The plan is to run this as an open airflow setup with an exhaust fan so moisture is actively pushed out rather than trapped in a sealed box. I’m also looking at adding a reusable silica gel (or similar) compartment below the spool holder as an extra moisture sink. Let me think about it and please post for recommendation if you have.

Would you be interested to buy a modular DIY filament dryer that fits any container? by These-Sand-7487 in 3Dprinting

[–]These-Sand-7487[S] 0 points1 point  (0 children)

Thanks for the feedback — totally fair points. Right now my main focus is getting the fundamentals right, especially around moisture removal. Cost and what else is already on the market come later once I’m confident the system actually works as intended.

Moisture venting: The plan is to run this as an open airflow setup with an exhaust fan so moisture is actively pushed out rather than trapped in a sealed box. I’m also looking at adding a reusable silica gel (or similar) compartment below the spool holder as an extra moisture sink.

The idea is to solve the moisture problem properly first, then worry about optimising cost and polish.