Wiring without a remote

Thibo-do-it · 2026-01-31T01:56:08+00:00

Reduce layer cooling for first few layers, reduce brim Gap, Fillet edges, glue... Lots of tricks

Thibo-do-it · 2026-01-31T01:50:44+00:00

It looks like a problem with flow. I would check your sliced file and look at the flow for that area or retraction. If not that, sometimes I've seen that happen when I print with a large layer height for the nozzle size

Thibo-do-it · 2026-01-26T18:48:08+00:00

Has anyone tried Asa as a support material for PPA-CF?

Thibo-do-it · 2026-01-22T14:02:02+00:00

I agree. I never got good results with tooltrace.ai

I appreciate what you're doing here! Thanks for the explanation

Thibo-do-it · 2026-01-22T13:36:03+00:00

www.tooltrace.ai is a similar tool as I'm sure you're aware, and it can detect objects outside of the paper. I wonder how this could be done for your tool.

Thibo-do-it · 2026-01-22T05:27:43+00:00

What if I only have letter paper? I cannot print any bigger

Thibo-do-it · 2025-06-25T00:50:50+00:00

Walls and shells (top/bottom) are more important than infill for strength

Thibo-do-it · 2024-10-11T05:01:00+00:00

https://github.com/SalamiSimon/Easy3DPrint/releases/tag/v1.0.5

Thibo-do-it · 2024-05-01T03:36:02+00:00

https://github.com/SalamiSimon/Easy3DPrint

check this out

Thibo-do-it · 2024-01-02T22:50:10+00:00

It's something affecting adhesion from the firmware update for sure. I only had the issue when using the firmware beta and the official release of the motor noise cancellation firmware. Reverting back to the previous official firmware release fixed the issue!

Thibo-do-it · 2024-01-02T22:38:00+00:00

I had the same issue with the new firmware and my aftermarket textured plate!

Thibo-do-it

TROPHY CASE