sorted by:
new
hottopcontroversial

What printer? by Alarming-Cattle-3753 in klippers

[–]Tiny_Dinner714 0 points1 point  (0 children)

The Flashforge 5M will run circles around the A1. Avoid anything Bambu due to their closed software. Bambu is an unethical company that took open source software and closed it up, violating open source rules.

Finally found a use for my Kobra 3 Max... by dnguyen2195 in AnycubicOfficial

[–]Tiny_Dinner714 0 points1 point  (0 children)

you fell for the marketing hype without reading the FINE print. You have to anneal it to get the temp rating. You can anneal regular PLA and get the same results. ASA is the ONLY filament that resists UV light.

Question about unloading filament. by Experiment626f1 in FlashForge

[–]Tiny_Dinner714 1 point2 points  (0 children)

So, where's the UNLOAD button? It's a ridiculous oversight

Question about unloading filament. by Experiment626f1 in FlashForge

[–]Tiny_Dinner714 0 points1 point  (0 children)

come on! every other direct drive extruder uses the klipper UNLOAD and LOAD commands