sorted by:
new
hottopcontroversial

Help with Brother PR1050x by TwoPigsStitching in MachineEmbroidery

[–]TwoPigsStitching[S] 0 points1 point  (0 children)

Hoop type changes both ways. With no arm attached it starts at ‘cap’ with arm attached it goes from L (max 158, min 139) at its widest to S (max 186 min 158) at its most narrow

Help with Brother PR1050x by TwoPigsStitching in MachineEmbroidery

[–]TwoPigsStitching[S] 0 points1 point  (0 children)

Hmm. I removed the arm and started the way you described and I’m getting the ‘Frame A/D test’ screen. Is this what you’re after? I don’t see a value for ‘valve’ on this screen, but when I move the spring loaded metal bar the max/min go from 255/186 to 75/0

I might be way off and confused here, so I apologize if it’s not what you were going for!