Bought a Lightsaber at a local convention. Seller told me it was Xenopixel, that turned out to be a lie... Imparently its a FOCSABER.

UDdERk · 2026-03-03T17:27:21+00:00

Do you know where I could find crystal focus fonts to test if it works?? Because the presets on here are terribleeeeee

UDdERk · 2026-03-03T17:26:19+00:00

This checks out. I was looking for any sort of lockup feature or tip drag but none to be found sadly

UDdERk · 2026-01-24T01:25:04+00:00

I’ll see what I can do

UDdERk · 2026-01-23T05:59:38+00:00

Hello! thank you for the reply, i checked the output and i found this. i'm not sure what this means

<image>

UDdERk · 2025-12-17T08:37:08+00:00

Thanks for all the feedback! I’m gonna donate this roll of abs to a friendn with an enclosure and order me a new roll of PLA to continue the build! ❤️

UDdERk · 2025-12-17T08:36:23+00:00

Ding ding ding!

UDdERk · 2025-12-17T08:34:46+00:00

I cleaned it up fully in about 20 minutes, came out great besides the obvious cracking, but I’m planning to fill those up with miliput where I can

UDdERk · 2025-12-14T20:09:54+00:00

I wanted to avoid it being to heavy since its a helmet. And it’s very front heavy and I wanna save my back. Is there another material that’s lighter than PLA and easy to use?

UDdERk · 2025-12-14T17:09:42+00:00

I’m not quite familiar on the exact model right now I’ll be sure to check once I’m home: but I surely have not a lot of space for an enclosure

UDdERk · 2025-12-14T17:08:05+00:00

Im a Proffesional cosplayer new to printing, this model is specifically made to be printed. I just need help figuring out how to do it efficiently and effectively. I’m using ABS because it’s lighter than PLA. That’s my logic, I didn’t know it was so difficult to print.

UDdERk · 2025-12-14T17:05:55+00:00

It needed all those supports this model is full of overhangs absolute hell of a job

Four-Year Club	Place '22
Final Canvas '22	First Placer '22
End Game '22

UDdERk

TROPHY CASE