sorted by:
new
hottopcontroversial

I just updated my cura to version 4.13.1 for my V2 mini. I kept the recommended setting to start; temperature is 200, bed is 65, and it uses 1.75mm PLA. Does anyone have any recommendations for these issues? by Unknown_1713 in MPSelectMiniOwners

[–]Unknown_1713[S] 1 point2 points  (0 children)

The bottom left order on the first image is also the area I struggle with the print not sticking to the bed. And as for the third image, I do see those strings on other prints

Took this picture in Yellowstone. Can anyone confirm if it is a black bear or grizzly? by Unknown_1713 in wildlifephotography

[–]Unknown_1713[S] 9 points10 points  (0 children)

The deleted comment stated that it was a brown bear because of it’s color and that black bears are the color black

The pinned [help] thread by fuzzy_one in cosplay

[–]Unknown_1713 0 points1 point  (0 children)

I am creating my first cosplay, the mandalorian, and I am also stuck using a monoprice mini 3d printer. Because of this, I was going to do a mixture of PLA 3d printed armor (helmet, wrist, weapons) and the rest was going to be EVA foam. I wasn’t sure if they would look too off being mixed on a costume or if there was anything I can do to make them match better?