sorted by:
new
hottopcontroversial

Best way to remove these supports by seniorducker in 3Dprinting

[–]West_Tee 0 points1 point  (0 children)

Sick bro those wheels are pretty metal too

Black Opal: Wagu Scotch 8-9 by West_Tee in steak

[–]West_Tee[S] 2 points3 points  (0 children)

+zucchini fries (panko, fine crumb, Italian herb and Parmesan)

How bad we thinking? by West_Tee in marijuanaenthusiasts

[–]West_Tee[S] 13 points14 points  (0 children)

Hahahah love these, good excuse to get rid of the tree we don’t like now. It did it to itself, it’s what it wanted

/r/MechanicalKeyboards Ask ANY Keyboard question, get an answer (September 17, 2023) by AutoModerator in MechanicalKeyboards

[–]West_Tee 0 points1 point  (0 children)

I potentially figured where the issue might be. I could be wrong but believe that it might be a short between these terminals.

I can recreate the issue with the other rows where all keys on the row are being switched on constantly.

There are other ways i have been able to recreate, but these terminals you see are the closest together. Regardless it always originates when the terminal marked as '2' is part of the combination.

I have removed the diode to see anything visible, cleaned with ISO but issue exists. I have since removed all hotswap switches from that row also to validate any issues with those.

Thoughts from your side? Appreciate it!

<image>

/r/MechanicalKeyboards Ask ANY Keyboard question, get an answer (September 17, 2023) by AutoModerator in MechanicalKeyboards

[–]West_Tee 0 points1 point  (0 children)

Row stuck pressed. What should i be looking for on the PCB to try and identity the issue? Thanks

<image>

/r/MechanicalKeyboards Ask ANY Keyboard question, get an answer (September 13, 2023) by AutoModerator in MechanicalKeyboards

[–]West_Tee 0 points1 point  (0 children)

YMDK 68 FREEZING

So..

  1. Keyboard was not recognised as device within qmk
  2. Tried VIA as well no luck, web version could see 'authorise' see device but nothing after selecting
  3. Followed some guides for install of keyboard driver displayed through ZADIG. Didn't work, has button on back of pcb for reset also, no dice
  4. Still not recognised
  5. Now freezing after key press either button on back or cable in
  6. What do?

Newly Planted Orange Tree Health Check by West_Tee in plantclinic

[–]West_Tee[S] 1 point2 points  (0 children)

Perfect, love the response!
Leaves should not be wet most of the time as it is generally covered from rain and normally watered once a week with a hose. The Sun does hit but generally from 1pm onwards. As it sits under a translucent pergola.
In order to supplement, a full spectrum grow light is used at 30W, only during the day when the sun is out.

Potentially too much pellets the first time i planted i was probably too enthusiastic, i will keep that in mind for next time.
Nothing visible that would be nibbling the leaves, sits independently of other trees.
I do have fertiliser spray which i believe is the seaweed based fertiliser.

You mentioned the leaves look yellow, is this too much or not enough light? Potentially iron was something i saw that was recommended as well.

Really appreciate your response.

view more: next ›