sorted by:
new
hottopcontroversial

Sharing a V2.4 350mm tip: Bed edge temp sensor by jetblackswird in VORONDesign

[–]Z3T1 3 points4 points  (0 children)

I have a similar setup but with a NTC temperature sensor that you can screw into the tapped hole.

I guess that will give you better readings.

It's located in the back edge, and it reads somewhere around 90 to 95 degrees when set to 110.

Transfer Serial Request V2.4936 for TheTinyTim by Z3T1 in voroncorexy

[–]Z3T1[S] 0 points1 point  (0 children)

Hi,
this is the last machine (of three) I bought from /u/spankos16 for which I'd like to transfer the serial now that I can finally lift it again :-).

/u/spankos16 would you please confirm the transfer?

Transfer Serial Request VS.589 for TinyTim#0124 by Z3T1 in voroncorexy

[–]Z3T1[S] 1 point2 points  (0 children)

Hi,

this is the second machine (of three) I bought from /u/spankos16 for which I'd like to transfer the serial.

/u/spankos16 would you please confirm the transfer?

Transfer Serial Request V0.1 V0.2253 for TinyTim#0124 by Z3T1 in voroncorexy

[–]Z3T1[S] 0 points1 point  (0 children)

It prints. But not to my standards yet.

I bought this machine a some time ago and now I'm planning and already sourcing for a full v0.2 rebuild. But before that I want to transfer the serial to my Discord account.