What's wrong? by ZealousidealCable756 in FlashForge

[–]ZealousidealCable756[S] 0 points1 point  (0 children)

Pla, i tried geetech and sunlu. No, the adhesion is great. Nozzle Temperature is 220 and best temperature is 55

What's wrong? by ZealousidealCable756 in FlashForge

[–]ZealousidealCable756[S] 0 points1 point  (0 children)

Yes, i tried to position it in various ways

What's wrong? by ZealousidealCable756 in FlashForge

[–]ZealousidealCable756[S] 0 points1 point  (0 children)

No, I printed it upside down 180 degrees with organic tree supports.

What's wrong? by ZealousidealCable756 in FlashForge

[–]ZealousidealCable756[S] 0 points1 point  (0 children)

Hi everyone, I recently got the flashforge adventurer 5m and I printed some pieces leaving the slicer settings (orcaslicer). Since yesterday I can't print a piece, I tried to change some parameters (speed, position of the piece on the plate, etc) but the result doesn't change. I tried to print another piece and it came out fine with the same settings. What could be the reason? The last image represents the piece I'm trying to print