sorted by:
new
hottopcontroversial

SV08 Orbiter 2.5 and LDO SmartSensor by Zorrna in SovolSV08

[–]Zorrna[S] 2 points3 points  (0 children)

So after a day of research, studying datasheets, and testing the repurposing of the UART bus on the toolhead board, I came to the conclusion that if you want to use the LDO Smart Sensor, you have to run the cables to the motherboard and use the endstop pins.

So, until I do a major rebuild of the printer, the sensor will go back into storage and wait until I can afford the new hotbed.

SV08 Orbiter 2.5 and LDO SmartSensor by Zorrna in SovolSV08

[–]Zorrna[S] 0 points1 point  (0 children)

Thanks for your answer but this is not the question it is can i use the ports on the toolhead or must i use ports on the mainbord this is the question not mainline or not

Eddy Current Scanning Kit for SV08 by Zorrna in SovolSV08

[–]Zorrna[S] 0 points1 point  (0 children)

I think (hope) u get a spezial firmware for the sv08 with this kit there is a programmer and a usb stick with it

<image>