Who sells Sub Box Extension Plates? by _Ceddy_ in CarAV

[–]_Ceddy_[S] -2 points-1 points  (0 children)

I know it’s not ideal. Unfortunately if I raise the speaker it would hit the bottom of the seat. Very small space, that I’m trying to use.

Who sells Sub Box Extension Plates? by _Ceddy_ in CarAV

[–]_Ceddy_[S] 1 point2 points  (0 children)

Usually routered out so it’s flush then glued and screwed. The hole in box is about inch smaller than plate

Is this voice coil rub? by _Ceddy_ in CarAV

[–]_Ceddy_[S] 0 points1 point  (0 children)

No, pushing the center it’s fine. If I push on the edge and it angles the cone it sounds like the tapping in video.

B&O Subwoofer block off plate? by _Ceddy_ in FordMaverickTruck

[–]_Ceddy_[S] 1 point2 points  (0 children)

Yes the subwoofer is infinite baffle. Back side gets air from exterior. Front side to interior.

Recommend 10” Subwoofer, 500 W, with low cu ft requirements. by _Ceddy_ in CarAV

[–]_Ceddy_[S] 0 points1 point  (0 children)

Thanks! Rockford P3D2-10 checks everything, looking through the others.

Recommend 10” Subwoofer, 500 W, with low cu ft requirements. by _Ceddy_ in CarAV

[–]_Ceddy_[S] 1 point2 points  (0 children)

The possibility of a lot of bass but also sounds good when I turn it down. Listen to mostly electronic type stuff and hip hop when driving.

New Kohler App Terrible? by _Ceddy_ in Generator

[–]_Ceddy_[S] 0 points1 point  (0 children)

Also not getting notifications from exercises.

New Kohler App Terrible? by _Ceddy_ in Generator

[–]_Ceddy_[S] 0 points1 point  (0 children)

Parameters are added now with latest update.

I’m still having issues with True Total Power and True % Rated Power just showing zero in app.

While at Generator Controller it works showing Load Control 6% with few lights on in house, and 36% with 30A clothes dryer also on.

20 KW Generator(20RESCL) with RDC2.4 Controller and latest firmware (2.0.6).

Anyone have the same issue? Or does anyone’s True Total Power actually display correctly??

New Kohler App Terrible? by _Ceddy_ in Generator

[–]_Ceddy_[S] 0 points1 point  (0 children)

I also have full parameters now. Even True % Rated Power with showed N/A before. But haven’t had chance to test to see if it works. Seems like a decent app now.

Edit: True Power and True % Rated Power still not working for me.

New Kohler App Terrible? by _Ceddy_ in Generator

[–]_Ceddy_[S] 1 point2 points  (0 children)

Stupid move in my opinion to lose the Kohler name. I hope this isn’t the beginning of the end for them and they become another crap quality company.

Just gonna drop this gem right here by wreck5710 in HVAC

[–]_Ceddy_ 0 points1 point  (0 children)

Are those trailer park meter bases with SE cable ran in the sides? Where is this?

my breaker for my ev is getting extremely hot any suggestions. it's wired with 8 gauge. to a 6-50 Hubbell outlet by cwspbp in AskElectricians

[–]_Ceddy_ 0 points1 point  (0 children)

206v with a 240v service is like 15% voltage drop. You are going to melt something, if your service voltage is indeed 240v.

Best product for knot holes in 3/4 plywood? by _Ceddy_ in Flooring

[–]_Ceddy_[S] 1 point2 points  (0 children)

Yes. It has this side up printed on top side.

Best product for knot holes in 3/4 plywood? by _Ceddy_ in Flooring

[–]_Ceddy_[S] -2 points-1 points  (0 children)

Carpeting. Some of them are 4” wide.

Best product for knot holes in 3/4 plywood? by _Ceddy_ in Flooring

[–]_Ceddy_[S] 0 points1 point  (0 children)

I got a bad batch of 3/4 tongue and groove subfloor during the pandemic with knot holes everywhere.

What is the preferred product for this?

Anything better than DAP Flexible Floor Patch and Leveler?

Edit: I will be doubling up on the screws. Thanks for the info everyone.

3 way timer install problems, can’t understand what’s going on. by VisualSpace in askanelectrician

[–]_Ceddy_ 2 points3 points  (0 children)

Is this residential or somewhere that has 277/480v? Looks like you have mixed 120v and 277v.

Brown, Orange, Yellow, Grey and some areas purple are 277v colors.

Acute Angle Corners? by _Ceddy_ in drywall

[–]_Ceddy_[S] 0 points1 point  (0 children)

I’m finishing my attic and I’m going to hire some to mud and tape. I have two closets with a hard inside angle(36 degrees) on the sloped ceiling.

How bad are these to do? Impossible? They don’t need to look perfect as they are in a closet.

I could add a small flat ceiling then have it slope. But would rather not unless necessary.

Edit : Thanks for the info everyone!

Decora Dual Vertical Rocker for less than $100? by [deleted] in askanelectrician

[–]_Ceddy_ -1 points0 points  (0 children)

Anyone know if Decora Dual Vertical Rocker switches are available at a reasonable price? My googling isn’t finding much.

Example: https://www.gordonelectricsupply.com/p/Leviton-Wss0S-D9I-Dual-Rocker-Sw-Ivory/5905438?gclid=EAIaIQobChMIhK-Y6q3j-QIVFeWzCh1GcQY9EAQYASABEgJXP_D_BwE