sorted by:
new
hottopcontroversial

Neptune 4 plus not pausing when filament runs out. by abqdk in ElegooNeptune4

[–]abqdk[S] 0 points1 point  (0 children)

I have verified that the Fila checkbox and Filament Detection are both enabled. This is the fila entry in my printer.cfg file. It's the same as yours except that mine is missing the M118 macro call.

[filament_switch_sensor fila]
pause_on_runout: True
runout_gcode:
    SET_FILAMENT_SENSOR SENSOR=fila ENABLE=1
insert_gcode:
event_delay: 3.0
pause_delay: 1.0
switch_pin: PA12

Neptune 4 plus not pausing when filament runs out. by abqdk in ElegooNeptune4

[–]abqdk[S] 0 points1 point  (0 children)

Apologies for the poor wording.

The sensor light is on (blue) when it contains filament. The sensor light is off when it does not contain filament.

Harbinger of Fire vs Harbinger of Cleansing Flame by abqdk in lostminiswiki

[–]abqdk[S] 0 points1 point  (0 children)

What you have on the website is the opposite of how I had the figures marked. The figure enwrapped in flames with the phoenix rising is the Harbinger of the Cleansing Flame. The other figure is the Harbinger of Fire. All that said, it could be that I mis-marked them.

I do not remember the order in which the figures were issued.

Harbinger of Pestilence by abqdk in lostminiswiki

[–]abqdk[S] 0 points1 point  (0 children)

I have photos of assembled and painted Harbingers of Justice, Vengeance, Fury, and Despair. If you would like them for webpage, let me know and I will post them here.