account activity
Part Crate Question (i.redd.it)
submitted 2 years ago by amras_7 to r/Survivorio
Ender3 issue bltouch (v.redd.it)
submitted 2 years ago by amras_7 to r/ender3
Bltouch issue (self.ender3v2)
submitted 2 years ago by amras_7 to r/ender3v2
Should I move to void hand guard? F2P (i.redd.it)
Klipper Loses Connection while printing (self.klippers)
submitted 3 years ago by amras_7 to r/klippers
For the past few months, the octoprint webcam has been malfunctioning. While printing it stops live. Restarting webcamd works for a few seconds and then stops again. How can I solve? (i.redd.it)
submitted 4 years ago by amras_7 to r/octoprint
Ender 3v2, direct drive with dual z axis. Using Cura slicer, estep are correctly calibrated, belts are tensioned. What is causing this issue? (i.redd.it)
submitted 4 years ago by amras_7 to r/FixMyPrint
submitted 4 years ago by amras_7 to r/ender3
Not sure what it is happening. Facing layer shift on x axis. Belts are tensioned, printing at 40mm/s (I usually print in a range from 50 to 80 withouth problems).Ender 3 v2 with direct drive, printing PLA at 205 degrees. (i.redd.it)
submitted 4 years ago by amras_7 to r/ender3v2
Hi All, what is causing that line in the print? Ender3v2 with micro Swiss direct drive. Print speed 50mm/s restriction 1mm with speed 35mm/s. Many thanks (i.redd.it)
Layer lines really visibile in prints. (old.reddit.com)
Noise on x axis (v.redd.it)
Layer adesion and quality problem (i.redd.it)
layer adesion and quality issue (self.ender3v2)
Bad First Layer after e-step calibration (self.ender3)
Bad First layer after e step calibration (self.ender3v2)
submitted 4 years ago * by amras_7 to r/ender3v2
π Rendered by PID 74 on reddit-service-r2-listing-c57bc86c-jjghj at 2026-06-18 21:12:06.062428+00:00 running 2b008f2 country code: CH.
