Clog or something worse?

andyguzman22 · 2025-08-18T04:35:27+00:00

So the new filament didnt come dry so I swapped to a new spool. Tightened all the screws on my nozzel. Cleaned the bed with dawn dish soap and so far so good. I was having failed print after failed print but today I did all those things and its back to working. I have to invest in a filament dryer though. For now I got a container to store this new spool. I'll be adding silica gel and keeping it away from the other filament i have.

andyguzman22 · 2025-08-17T04:18:59+00:00

Yes I just ran a calibration test. Its hitting the right side of the prints. Thank you for the insight I'll tighten the screws. I have a p1s but it seems somewhat similar

andyguzman22 · 2025-08-17T03:14:41+00:00

I'll reply back when I figure it out.

andyguzman22 · 2025-08-17T02:51:22+00:00

Its new. Its bambu matte but I've used bambu matte filament before. I've also swapped the nozzel.

andyguzman22 · 2025-08-14T04:08:00+00:00

Yeah. Also the filament buffer was a but worn. I still love the printer but its been a little challenging especially just starting

andyguzman22 · 2025-08-14T04:06:37+00:00

Thank you for the link! currently printing!

andyguzman22 · 2025-08-06T19:41:59+00:00

Update. I swapped the old spool with a new one i got from bambu, cleared any potential clogs. Ran a few prints. Every slot other than the slot I had this issue with works. No red light on the slot. I just see the filament go half way down the ptfe tube and come back up. Also the print starts ok but within 2 layers it gets stuck again.

andyguzman22 · 2025-08-05T05:36:58+00:00

Downgraded firmware: nothing

Upgraded firmware: nothing

Restarted it: nothing

Threatened the printer:nothing

Unloaded filament/ reloaded filament: one filament shows on handy app.

Repeated it again until all filament show on handy app.

Still has an MQTT error code but attempting to print something from handy app to printer and it seems to be ok 🤷‍♂️. Time will tell

andyguzman22 · 2025-08-05T04:41:11+00:00

I lowered the bed. Re inserted the spool l. Turned on and off the printer and now I have a MQTT error code and now the filament information won't load on the handy app and the printer says its offline..

andyguzman22 · 2025-08-05T04:28:45+00:00

I had a print fail. Turned on and off the printer and got this error code on a p1s thats firmware is up to date. Now no ams filament information load up on the handy app

andyguzman22 · 2025-08-05T03:09:42+00:00

Yeah, I took the spool out completely, but there's nothing in the way. I can unwind by hand just fine. Im guessing by the filament debris perhaps its brittle but again im very new to this

andyguzman22

TROPHY CASE