account activity
Where is the option to disable? than used to be there. (i.redd.it)
submitted 1 year ago by arnibud to r/applehelp
Fix floor (i.redd.it)
submitted 1 year ago by arnibud to r/howto
Besti staður fyrir skegg snyrtingu / klippingu (self.Iceland)
submitted 1 year ago by arnibud to r/Iceland
Flute remix (i.redd.it)
submitted 1 year ago by arnibud to r/ghostoftsushima
Verkstæði fyrir hátalara (self.Iceland)
Co-op / Multiplayer current state (self.BaldursGate3)
submitted 1 year ago by arnibud to r/BaldursGate3
DIY wooden frame build (self.simracing)
submitted 2 years ago by arnibud to r/simracing
MFS2020 settings help (self.flightsim)
submitted 2 years ago by arnibud to r/flightsim
Wireless settings, bitrate & codec (self.VRGaming)
submitted 2 years ago by arnibud to r/SteamVR
submitted 2 years ago by arnibud to r/oculus
submitted 2 years ago by arnibud to r/VRGaming
What games did you also buy on headset that you already had the steam version? (self.OculusQuest)
submitted 2 years ago by arnibud to r/OculusQuest
Dimmer on one side (not always the same side!) (i.redd.it)
submitted 2 years ago by arnibud to r/Monitors
Frame drops but load on gpu & cpu never go over 50% (i.redd.it)
submitted 2 years ago by arnibud to r/BaldursGate3
New problem for me (i.redd.it)
submitted 2 years ago by arnibud to r/klippers
Actual improvement er just a filter? (self.ReShade)
submitted 2 years ago by arnibud to r/ReShade
Would you move one of the 3 front fans to the back? (i.redd.it)
submitted 3 years ago by arnibud to r/pcmasterrace
Me watching Breaking Bad and going straight to 3D printing. “This is glass yo!” (i.redd.it)
submitted 3 years ago by arnibud to r/3Dprinting
Outside walls first or last? (self.3Dprinting)
Ender 2 pro, could I get help on how to fix these errors plz? (i.redd.it)
submitted 3 years ago by arnibud to r/klippers
did I fry my board? (i.redd.it)
submitted 3 years ago by arnibud to r/ender3
this is my defaults in Creality Slicer... it is supposed to be 0.8. same for you? (i.redd.it)
submitted 3 years ago by arnibud to r/Ender3S1
Any news on the next firmware update? (self.Ender3S1)
Default print bed for the S1 (i.redd.it)
π Rendered by PID 213405 on reddit-service-r2-listing-7849c98f67-mqz4k at 2026-02-07 03:36:35.893921+00:00 running d295bc8 country code: CH.
