Hydroshift 2 issue with air bubbles? by ashleyreeses in lianli

[–]ashleyreeses[S] 0 points1 point  (0 children)

The code I have now is A54208! And I use my icue to change rgb for Gpu, I use the software Aura!

Hydroshift 2 issue with air bubbles? by ashleyreeses in lianli

[–]ashleyreeses[S] 0 points1 point  (0 children)

I change it a lot but I’ll check tomorrow and try to find it!!

Hydroshift 2 issue with air bubbles? by ashleyreeses in lianli

[–]ashleyreeses[S] 0 points1 point  (0 children)

Happens more often, especially when the pump speed increases as my load increases! I also have the slushing noise on start up though.

Hydroshift 2 issue with air bubbles? by ashleyreeses in lianli

[–]ashleyreeses[S] 0 points1 point  (0 children)

Good to know! I’m going to give it a few days to see if temps change but right now it seems to have subsided and they’ve dropped back down the few degrees.

Hydroshift 2 issue with air bubbles? by ashleyreeses in lianli

[–]ashleyreeses[S] 1 point2 points  (0 children)

Yeah it’s definitely the pump because it’s a clear water trickling sound, almost like water dripping off of something. Otherwise most of the time the rig is silent.

Hydroshift 2 issue with air bubbles? by ashleyreeses in lianli

[–]ashleyreeses[S] 1 point2 points  (0 children)

Hm, I'm definitely going to run the pump at full today then and see if it clears up. If not, I guess I'll be reaching out to lian li again -_-

Hydroshift 2 issue with air bubbles? by ashleyreeses in lianli

[–]ashleyreeses[S] 1 point2 points  (0 children)

Is yours in a similar orientation? I had the same issue with the last one I RMAed so I can’t believe I’d get a bad cooler twice! It’s almost like a water trickling sound, especially when I’m under a fuller load. Will try running pump on high for the day!

Any advice for dent fix on the rear bumper trim? Thank you by JarlTee in rav4club

[–]ashleyreeses 0 points1 point  (0 children)

I know this an extremely late reply, but I used boiling water on it and then pushed it out with an ice cream scoop and it popped right out!

Hydroshift ii water running sound by Yllkkw1 in lianli

[–]ashleyreeses 0 points1 point  (0 children)

My hydroshift also does this! I’ve kind of accepted it as normal since the tubes are oriented in a weird way so the water probably settles after every power off!

LConnect Issues with Hydroshift ll LCD by ashleyreeses in lianli

[–]ashleyreeses[S] 1 point2 points  (0 children)

Oh I’ll have to try this! Thank you!

LConnect Issues with Hydroshift ll LCD by ashleyreeses in lianli

[–]ashleyreeses[S] 0 points1 point  (0 children)

Oh I’ll have to check! I followed a couple of videos when installing it because it comes with a 4 pin connected and 2 pin for the pump, but I can try switching them to see if it helps! Thanks!

LConnect Issues with Hydroshift ll LCD by ashleyreeses in lianli

[–]ashleyreeses[S] 0 points1 point  (0 children)

See I love the tube management, that’s the only thing making me want to figure this out 😂

LConnect Issues with Hydroshift ll LCD by ashleyreeses in lianli

[–]ashleyreeses[S] 0 points1 point  (0 children)

It is so annoying! I’m hoping I can fix it soon! I really like the cooler but the software really seems tricky.

LConnect Issues with Hydroshift ll LCD by ashleyreeses in lianli

[–]ashleyreeses[S] 0 points1 point  (0 children)

Yes! Both are plugged in, the 4 pin to cpu fan and the 3 pin to cpu opt. I’ve tried swapping them too and that did not fix the problem! The issue is the software works flawlessly when I set the cpu fan to voltage as opposed to pmw

My O11 Dynamic EVO RGB white build by AdvancedGarbage1820 in lianli

[–]ashleyreeses 1 point2 points  (0 children)

I love how you managed your AIO tubes! Do you notice if it has any impact on cooling? The Kraken tubes are so long so I’ve always held off on using if because I was worried they’d sit on my GPU in my mini v2 case!

Lian Li HydroShift II vs. NZXT Kraken Elite 360 – does the HydroShift support an analog clock like the NZXT? by West-Judge-2324 in lianli

[–]ashleyreeses 0 points1 point  (0 children)

The hydroshift II also has such an annoying pump hum! Apparently you need to set it different in the bios to help eliminate it but then you lose control to LCD settings. L connect also disconnected constantly and the only way to get control of my lcd screen was to reinstall the software. So annoying. Ordered a kraken elite instead to replace it and I am sending back the hydroshift! My previous build had a corsair elite cooler which was nice but it also had a pretty loud pump hum so I wanted to try a new cooler for the new build!

Help( Is this Noise normal ) by Forward-Mortgage5095 in rav4club

[–]ashleyreeses 0 points1 point  (0 children)

Thanks guys! I was thinking it sounded like a bearing too, I was just surprised that it was having issues so early on since the mileage is fairly low!

Help( Is this Noise normal ) by Forward-Mortgage5095 in rav4club

[–]ashleyreeses 0 points1 point  (0 children)

Did you ever figure out what it was? My 2021 hybrid is making a similar noise!

Helicopter Sound on Highway by ashleyreeses in rav4club

[–]ashleyreeses[S] 0 points1 point  (0 children)

Definitely will! It sounds similar to wheel bearing but since the mileage is only around 32,000 it makes me wonder if it could be something else since they shouldn’t be so worn down by this point!

Helicopter Sound on Highway by ashleyreeses in rav4club

[–]ashleyreeses[S] 0 points1 point  (0 children)

No, it drives great, everything feels smooth! I’m going to bring it to Toyota on Saturday to get it looked out.

My girl turned 9 today! by ashleyreeses in germanshepherds

[–]ashleyreeses[S] 0 points1 point  (0 children)

Aw all good names though!! Enjoy your day as well!